Fia TRS42-67, TR42-67, SP82-67, SL62-67, OE32-67 User Manual

SEAT COVERS

BY

FEATURING

SUPER-GRIP® THE SLIP RESISTANT FASTENING SYSTEM

INSTALLATION INSTRUCTIONS

FOR

NP92-67/ Oe32-67/ SL62-67/ SP82-67/ TR42-67/ TRS42-67

CUSHION COVERS

1. Center cover on seat

2. Lift cushion to halfway up position and pass back flap
through crevice

3. With cushion in up position locate straps and buckle to
back flap

4. smooth out cover and adjust straps to equalize tension
for a better fit

BACKREST COVERS

1. Remove headrests, (see note below)

2. Place cover over backrest. Ensure cover is installed
under seat belt strap

3. Ensure openings for headrest posts are tucked under
headrest base to reduce cover movement during
installation.

4. Pass strap with velcro behind the seat and attach velcro
to the bottom of cover

5. Pass center strap (60 cushion side) through opening on
metal seat belt base on floor and buckle

6. Anchor each center strap on metal seat belt base on the
floor and buckle

7. Secure top portion of backrest by placing adhesive velcro
supplied on flat surface behind the seat. NOTE: BEFORE

POSITIONING VELCRO, CLEAN AREA WITH ALCOHOL
SWAB PROVIDED

8. Smooth out cover and adjust straps/velcro to equalize
tension for a better fit.

NOTES:

1) SELF-LOCKING SUPER-GRIP® BUCKLE:

3) RE-INSTALLATION OF HEADRESTS

A) Ensure pre-cut holes in seat cover align with
holes in headrest base.
B) Replace headrests

2) HEAD REST REMOVAL:

Push in side release buttons

- Lift off
(If unable to remove
consult dealership)

WARNING: SEATS WITH INTEGRATED SEAT AIRBAGS MUST BE COVERED ONLY WITH SEATCOVERS DESIGNED WITH OPENINGS THAT
WILL NOT INTERFERE WITH THE DEPLOYMENT OF THE AIRBAG. NEVER INSTALL SEAT COVERS WITHOUT THESE OPENINGS AS THIS

MAY INTERFERE WITH THE PROPER DEPLOYMENT OF THE AIR BAGS AND COULD RESULT IN SERIOUS INJURY.

Fia Inc. Winnipeg, Canada R3L 0N3 Telephone [phone] Toll-Free: 1-800-835-0438
Fax: [phone] E-Mail: [e-mail] Website: www.gofia.com

04-08-19