FIA NP99-28, SL69-28, SP89-28, TR49-28, OE39-28 Installation Instructions Manual

NOTE: INSTALLATION IS EASIER IF YOU MOVE THE

SELF

-

LOCKING SUPER

-

GRIP® BUCKLE

2) HEAD REST REMOVAL:

3) RE

-

INSTALLATION OF HEADRESTS

If you have any comments or concerns,

SEAT COVERS

BY

please feel free to contact our

customer service department at:

Toll-free: 1-800-835-0438

OR

Email: [e-mail]

FEATURING

SUPER-GRIP®

THE SLIP RESISTANT FASTENING SYSTEM

INSTALLATION INSTRUCTIONS

FOR

NP99-28/ OE39-28/ SL69-28/ SP89-28/ TR49-28/ TRS49-28

Thank you for purchasing one of our fine quality products. Your seat cover is engineered from high quality materials and designed
with precision to give you a long-lasting, well-adjusted fit.

INSTRUCTIONS:

A) BACKREST COVERS – “40” PORTIONS:

1) Remove head rest (see note on reverse)

2) Move seat to most forward position

4) Tuck flaps through crevice, under plastic panel and up to
attach to Velcro at back

3) Slip cover over backrest and pull down firmly 5) Replace headrests (see note on reverse)

B) CUSHION COVERS –“40” PORTIONS:

1) Position cover on seat to allow seat belt buckles through
opening provided

2) Pass straps through crevice, under seat and buckle to
front

C) BACKREST COVER – “20” PORTION

1) Open armrest / storage compartment

2) Center cover under armrest

3) Snug cover at back of armrest so the velcro on the cover
is positioned through the crevice where lid and armrest are
hinged

D) CUSHION COVER –“20” PORTION

DRIVER’S SEAT FORWARD

1) Undo seat belt buckle from the elastic loop on seat

2) Center cover on the seat

3) Tuck front of cover between plastic organizer and seat

NOTES:

1)

:

3) Pass side straps through the opening between the molded
plastic and the seat

4) Pass the straps around the back and buckle

5) Adjust straps and buckles to equalize tension

4) Position adhesive back Velcro, supplied, to align with the
velcro on cover

NOTE: BEFORE PLACING VELCRO, CLEAN AREA WITH
ALCOHOL SWAB PROVIDED.

4) Pass side strap around back of seat and buckle

5) Position seat belt buckle through elastic loop on seat cover

6) Adjust straps and buckles to equalize tension

A) - Insert paper clip into holes at base to release

- Lift off
OR
B) - Push in side release buttons

- Lift off
(If unable to remove consult dealership)

- Ensure pre-cut holes in seat cover align with holes in base

- Replace headrest

WARNING: SEATS WITH INTEGRATED SEAT AIRBAGS MUST BE COVERED ONLY WITH SEATCOVERS
DESIGNED WITH OPENINGS THAT WILL NOT INTERFERE WITH THE DEPLOYMENT OF THE AIRBAG.
NEVER INSTALL SEAT COVERS WITHOUT THESE OPENINGS AS THIS MAY INTERFERE WITH THE PROPER
DEPLOYMENT OF THE AIR BAGS AND COULD RESULT IN SERIOUS INJURY.

Fia Inc. Winnipeg, Canada R3L 0N3 Telephone [phone] Toll-Free: 1-800-835-0438
Fax: [phone] E-Mail: [e-mail] Website: www.gofia.com

5-3-12