FFES Z00, Z01, Z10, Z11, Z02 Instruction Manual

...
FFES
Service: +48 888-777-053
Office: +48 796-149-338
e-mail: biuro@ffes.pl
www.ffes.pl/en
Instruction manual
FFES- FABRYCKI FUTURE ELECTRONIC SOLUTIONS 2016
2
Contents
1. Overview ......................................................................................................................... 3
1.1 Application ................................................................................................................ 4
1.2 Technical data ........................................................................................................... 4
2. Control panel operation ................................................................................................... 5
2.1 Profile choice ............................................................................................................. 6
2.2 Session temperature ................................................................................................. 6
2.3 Session time .............................................................................................................. 6
2.4 Power of vaporizer .................................................................................................... 7
2.5 Aromatherapy ........................................................................................................... 7
2.6 Ventilation ................................................................................................................. 7
2.7 Operation mode ........................................................................................................ 8
2.8 Menu ......................................................................................................................... 8
2.8.1 Light .................................................................................................................... 8
2.8.2 Timer ................................................................................................................... 9
2.8.3 Delay ................................................................................................................... 9
2.8.3 Hysteresis ............................................................................................................ 9
2.8.5 AUX ..................................................................................................................... 9
2.8.6 Language ........................................................................................................... 10
2.9 Musicotherapy ......................................................................................................... 10
2.10 Remote control ........................................................................................................ 10
2.11 Smart home ............................................................................................................. 10
2.12 Service mode ........................................................................................................... 11
2.13 Troubleshooting ...................................................................................................... 11
3. Installation of the controller .......................................................................................... 12
3.1 Block diagram .......................................................................................................... 13
3.2 Electrical diagram .................................................................................................... 14
4. Terms of warranty ......................................................................................................... 19
FFES- FABRYCKI FUTURE ELECTRONIC SOLUTIONS 2016
3
1. Overview
This manual is intended to familiarize the user with the operation and installation of the controller. The third chapter is solely dedicated to authorized persons with electrical qualifications. The controller should only be used by an adult. In case of failure to comply with the manual rules and instructions, the product is no longer covered by the warranty.
This user manual is universal for the entire series of ZXX controllers, whose explanation is shown in the table below.
ZXX
Model
Explanation
Z00
Steam room
Z01/Z10
Heater/IR: 9KW
Z11
Heater: 9KW + IR: 5KW
Z02/Z20
Heater/IR: 15KW
Z12
Heater: 15KW + IR: 5KW
Z22
Heater: 15KW + IR: 9KW
Z03/Z30
Heater/IR: 22KW
Z13
Heater: 22KW + IR: 9KW
Z04/Z40
Heater/IR: 30KW
Z24
Heater: 30KW + IR: 15KW
Versions ZXXP support Combi heaters with a vaporizer of power 3KW or 5KW.
Versions ZXXB support audio system
Versions ZXXW support remote control
FFES- FABRYCKI FUTURE ELECTRONIC SOLUTIONS 2016
4
1.1 Application
FESS ZXX controller is a Polish product, designed to control the operation of the IR, dry, wet saunas and a steam bath. It is powered by three-phase voltage, and in the case of steam and small IR saunas by single-phase voltage. The controller monitors and controls the devices such as a heater, vaporizer, infrared panels, steam generator, fan, light, and aromatherapy dispenser. The work of these devices depends on the settings that the user enters, and on the temperature measurement.
1.2 Technical data
The controller is a set of components consisting of the main unit, control panel and a temperature sensor. The technical data is shown in the table below.
Supply Voltage
3N~ 400V/50HZ or 1N~ 230V/50Hz
Power consumption module+panels+sensor
5W
Maximum load for the periphery
3x100W
Operating temperature of module, panel
0 -60oC
Set temperature
Baths 20-50 oC IR 30-60oC Heater 30-110oC Combi heater 30-65 oC
Set operation time
1min-20h
Delay time
1min-24h
Temperature measurement range
0-127oC
Thermal protection
Heater: +125oC IR/Baths/Combi: +80 oC
Thermal fuse: 140 oC
Hysteresis
1-6oC
Dimensions of the main module Ingress Protection Rating
9KW/15KW: 248 x 198 x 116mm
22KW/30KW: 348 x 228 x 166mm
IP65
Dimensions of the control panel Ingress Protection Rating
166 x 114 x 33mm
IP40
Dimensions of the temperature sensor
50 x 40 x 28mm
Audio
Class D Amplifier 2x10W RMS 8Ω
Bluetooth 3.0
FFES- FABRYCKI FUTURE ELECTRONIC SOLUTIONS 2016
5
2. Control panel operation
The panel is made of tempered glass and a metallic cover. It is operated by five touch buttons and a two-line alphanumeric OLED display. To activate the controller, button ON should be pressed for about 2 seconds, to turn it off do the same with button OFF. After exiting the standby mode, a start-up screen will open, and next a window with profile selection. The steps are described in the following sections.
Increasing Next the value Accept Turn on
Enter the menu EXIT Exit the menu Stop operation Turn off
Decreasing
the value
FFES- FABRYCKI FUTURE ELECTRONIC SOLUTIONS 2016
6
2.1 Profile choice
The first step to start the session is to choose a profile. Depending on the controller model there is a choice of a steam bath, dry sauna, infrared sauna, wet sauna and a ventilation profile. After selecting a dry sauna, depending on the temperature and time, the heater will be turned on/off, with IR sauna infrared heaters, and for steam bath a steam generator. For ventilation, operation time of the fan can be determined.
2.2 Session temperature
The next step is to determine the temperature. In the case of dry sauna it may be 30­110oC , for steam bath 20-50 oC, wet sauna 30-65 oC, and for IR sauna 30-60oC .
2.3 Session time
The next step, sets operation time of the sauna session, it is counted from the moment in which the heater, steam generators or infrared heater are started. First, you have to set the number of hours, after pressing OK button, determine the number of minutes. When determining the time, keep in mind the sauna’s heat-up time. Session time can be a maximum of 20 hours.
FFES- FABRYCKI FUTURE ELECTRONIC SOLUTIONS 2016
7
2.4 Power of vaporizer
This stage is available only for the sauna with a combi heater. At this stage, power of vaporizer is determined. Power of vaporizer is the percentage of the vaporizer’s time cycle, which lasts for 2 minutes.
Example: The set value is 10%, in this case the vaporizer runs for 12 seconds. And for the remaining time of 108 seconds it will be turned off. This cycle takes place in a loop that ends with the end of the session.
2.5 Aromatherapy
The course of this step is analogous to the one above with the addition of cycle regulation of aromatherapy dispenser. The dispenser cycle may be within the range from 1 to 10 minutes, an adjustment is made through the MENU.
2.6 Ventilation
The final step in the transition into operation mode is to provide time of ventilation,
which will be launched after finished session. When you touch the button to increase the value, minutes also change, and after reaching 59 minutes also hours. Ventilation time cannot be longer than 2 hours. When choosing 00:00, ventilation will not start.
For wet sauna, auto drying mode is available, in which after finished session, the heater
is activated for 15 minutes at the set temperature of 75 ° C. The user at this stage can select it or abandon it.
Loading...
+ 14 hidden pages