Fervi A901A Operation And Maintenance Manual
OPERATION AND
MAINTENANCE MANUAL
LVMP spray gun
Art. A901A
TRANSLATION OF THE ORIGINAL INSTRUCTIONS
fervi.com
HARDWARE
Page
2of9
PREFACE
Please
ensure you have read this manual before any
operation
TRANSLATION OF THE ORIGINAL INSTRUCTIONS
It is compulsory to read this instruction manual before starting operation. The guarantee of
smooth operation and full performance of the product is highly
dependent on the application
of all the instructions contained in this manual.
Operator Qualifications
The workers responsible for using this product must have all the necessary information,
education and receive adequate training regarding safety,
including:
a)
Conditions of use for the equipment;
b)
Foreseeable abnormal situations, pursuant to Article 73 of Legislative Decree
81/08.
We guarantee the product's conformity to specifications and technical instructions
described in the Manual on the date
of issue, listed on this page; however, the product
may be subject to potentially major technical changes in the future, without the
Manual being updated.
Therefore, contact FERVI for information about modifications that may have been
implemented.
REV.
2
November
2013
fervi.com
HARDWARE
1
GENERAL SAFETY INSTR
1.1
Commissioning
Before using this spray gun, some simple assembly is required.
To properly assemble the spray gun, proceed as follows:
1.
Screw on the compressed air coupling and tighten it firmly
using a
hexagonal wrench.
2.
Insert the paint filter, with the filtering part facing
downwards, inside the opening where the tank will be
screwed in, positioned on top of the spray gun.
3.
Screw the paint tank into the
the spray gun.
1.2
How to Use the Spray Gun
The minimum operating pressure is 0.2
Adjust the amount of paint and air released from the nozzle
via the three adjustment knobs.
UCTIONS
opening positioned on top of
–
0.25 MPa.
Figure
Page
3of9
Figure
1-Air inlet
Figure
2-Tank
3–Adjustment knob.
fervi.com
Loading...