Page 1
1
© Copyright 2006 Ferris Industries. All Rights Reserved.
5100523
Rev. 1/2006
TP 200-7280-00-AT-SMN
WARNING
Before beginning any service work turn off the
PTO, set the parking brake, turn off the ignition,
and disconnect the spark plug wire(s).
1. Park machine on a flat, level surface and engage the
parking brake. Diesengage the PTO switch, turn off
the engine and remove the key from the ignition.
2. If the engine is hot, allow sufficient time for the muffler to cool to prevent a burn injury during installation.
3. Install the 3/8-16 x 2-1/2” bolts (B) through the hitch
plate (A).
4. Install the hitch plate onto the bumper with the bolts
in between the bottom and middle bumper tubes.
5. Install the back plate (C) and loosely secure with the
3/8-16 nylock flange nuts (D).
6. Center the hitch plate side-to-side on the bumper
and tighten the hardware securely.
Installation
Instructions
Trailer Hitch Kit
Part No. 5600056
Fits 2006 Simplicity Champion Series
Fits 2006 Snapper and Massey Ferguson Consumer Z Series
Figure 1. Install Hitch Kit
A. Hitch Plate
B. 3/8-16 x 2-1/2” Bolts (4X)
C. Back Plate
D. 3/8-16 Nylock Flange Nut (4X)
B
A
C
D
Kit Contents:
Part No. Qty. Description
5401582 1 Hitch Plate Assembly
5401581A 1 Back Plate
5025013X20 4 3/8-16 x 2-1/2” Bolt
5025394 4 3/8-16 Nylock Flange Nut
Loading...