Ferrari LaFerrari User Manual

USER MANUAL
Safety
D
Warning
The vehicle, which has been designed and produced for road use, should only be used occasionally on race tracks. Always use the same care when driving on track as you would when driving on roads.
Warning
Not all drivers will achieve the same performance and lap times. The data provided by the system is approximate and should therefore be used with caution.
Warning
Seat belts must be worn at all times and must be properly fastened and adjusted!
Warning
In low- to medium-grip conditions (e.g. wet, icy, sandy roads), activate the WET driving mode and do not deactivate the ESC.
Warning
Data management and analysis cannot be performed when the vehicle is moving. Video playing is only possible when the electric parking brake (EPB) is activated. If it is not, the system automatically disables these functions.
Introduction
This vehicle is fitted with the optional TELEMETRY KIT. The TELEMETRY KIT acquires all the information on driving on a
specific track in real time and then presents it to the driver so that it can be compared and analysed. Information acquired from different drivers driving on the same track can also be compared.
User interface
The TELEMETRY KIT information is display.
The driver can interact with the system by selecting the configuration and setting the parameters using the controls on the dashboard to the right of the steering wheel (see the Owner's Manual).
displayed on the right TFT
System initialisation
To access the TELEM ETRY KIT function from the main infotainment system menu, press joystick D on the right satellite.
Rotate the joystick to go from one screen to another.
The system displays the following message:
I declare that I have read and understood all the information in the supplied manual”.
Read the warnings on page 2 carefully and confirm to access the RACE mode menu.
Important note
For the LaFerrari model, the system can only be initialised in Race configuration. For further information, refer to the Owner's Manual.
USB connection
The cnnector used for the TELEMETRY KIT USB key is located in the following positions depending on the car model:
• 458 - centre console, front
• F12berlinetta - glove compartment
• LaFerrari - pocket change compartment on passenger side
Race Configuration
When the RACE screen is displayed, press the MENU button on the right satellite to access the Race Configuration menu which has four items:
• Driver's Name
• Number of Laps
• Compare with
• iPad password
2
Telemetry Kit
Telemetry Kit
3
Driver's Name
Use Driver's Name to select the name of the driver used to record the subsequent race sessions. All lap times will be attributed to the selected name.
Number of Laps
Use Number of Laps to select the number of laps that the system will record time for during the next session. If the parameter is set to “Unlimited”, times and laps can be recorded until the session is stopped manually.
Compare with
Use Compare with to select whether to compare the lap that is being driven with the Best Overall Lap, the Best Personal Lap or the Best
Lap in the Session.
iPad password
Use iPad password to display the numeric code required to connect the car system to the iPad application.
Settings
Important note
The settings described below may not be present in all car models.
When the RACE, ANALYSIS or SYS screens are displayed, if you hold down the SETUP button on the right satellite, you can access the Settings menu where you can modify the camera settings (OPTIONAL RACE CAMERA) and the video recording mode.
Video options
The video recording mode uses two cameras (optional), an external one that films the vehicle trajectory and an internal one that films the driver's driving behaviour. In the video layout configuration menu you can select which of the two views to set as the main one and decide whether to display the track map icon in overlay.
Camera setup
Select external/internal video preview:
• The external camera can be adjusted in all four directions (up/ down/left/right) by moving the joystick.
• The internal camera can be adjusted in two directions (up/down) by moving the joystick.
Important note
If the driver has a passenger on board the vehicle, the driver must inform the passenger that his/her image and voice may be recorded and played and that a GPS system will be activated.
4
Telemetry Kit
Telemetry Kit
5
RACE Mode
The RACE screen displays three menu items:
• Race On
• Start (New Track)
• Status Info
Important note
If you want to use a track map pre-loaded on the USB key, you must import it into the system using the special function (see page 15).
The icons displayed in the bottom left light up with different colours according to the operating status of the Wi-Fi, USB key and GPS:
Wi-Fi not connected - grey .......................................................
Wi-Fi connected - green ............................................................
Wi-Fi faulty - red...........................................................................
USB not present - grey ...............................................................
USB present - white ....................................................................
USB recording - green with input arrow ............................
USB faulty - red ............................................................................
GPS not connected - grey .........................................................
GPS connected - green ..............................................................
GPS signal poor - yellow ...........................................................
GPS faulty - red .............................................................................
see page 7
Race On
The Race On mode is only available when the vehicle is close to a track previously saved in the system. If the vehicle is at a distance of less than 500 m from a saved track, you can start a race session on the preselected circuit by pressing the Joystick button on the right satellite.
The system asks you to select the track (see page 6) and informs you that time, video (optional) and audio (optional) data will be recorded. The screen remains visible for 5 seconds and if no action is taken, the system records the data. The system indicates the maximum duration allowed for the session before the warm-up lap starts.
When the vehicle crosses the START line, the system begins to record the time and telemetry data.
To quit the race session, press the QUIT key or press the BACK button on the right satellite: a choice screen remains visible for 5 seconds. Select OK to exit. If no action is taken, the system continues to record and zoom out by pushing it down.
Once you exit the Race On mode, the driving data is saved in the current session for the selected track. If a session is interrupted before the end of the first lap, the telemetric data will not be saved.
driving
data. You can zoom in by pushing the Joystick up
Important note
Once the race session has ended, the track name/driver's name/ track map name cannot be entered while the vehicle is moving. However, the track map will be saved as “unnamed” on the USB key as long as the vehicle continues to move.
6
Telemetry Kit
Telemetry Kit
7
Loading...
+ 7 hidden pages