Fern-Howard FHBL9065-160 Installation Instructions

Pre-Installation Notes

Micro

This tting must be installed by a qualied electrician
and wired in accordance with the latest edition of the IEE
Electrical Regulations.

Make sure that the ‘Incoming Mains Supply’ is switched off
before working on this luminaire.

Information regarding Part Number, Description, Voltage,
Frequency, IP rating and Lumens is shown on the label
afxed to the box containing the luminaire.

High voltage insulation test equipment “Must Not” be
used on luminaires.

The luminaire is suitable for use within ambient temperature
ranges of -100C to +250C only.

However, particular attention should be paid to the
temperature range for Emergency ttings. Installations that
regularly drop below 00C for prolonged periods, particularly
when the luminaire is not illuminated are likely to result in a
shortened battery life. In such applications regular testing
and battery replacement schedule is recommended.

Performance and Warranty

This product is warranted for twelve months from the date
of installation, provided that the installation is carried out
within two months of purchase, subject to the following
conditions:

• This warranty will only be valid if the ttings have

remained unmodied and used as per this instruction
leaet and our literature.

• Fern-Howard Ltd. shall not be liable for any

consequential loss or damage caused directly or
indirectly by any defective or otherwise.

• Battery packs are guaranteed for 12 months but are

expected to have a life of at least four years if used
within the specied temperature limits and tested in
accordance with the standards in our literature.

Technical Data

Specic data sheets can be downloaded from our website
www.fernhoward.com

Nobody but Fern-Howard gives you
the same value for money, quality and range

Galaxy LED Bulkheads - Installation Instructions

Hinged

Lighting

gear

CONTROL

Options

Fern-Howard Ltd, 2 Newman Lane, Alton, Hampshire, GU34 2QR, United Kingdom.

It is the responsibility of the installer to ensure correct installation. Fern-Howard do not accept any loss or damage to the
product, private property and/or persons due to inadequate or incorrect installation.
Fern-Howard reserve the right to alter the specifications and/or improve products without prior notice.

tray

wave

SENSOR

RoHS

FHLP0002 | ISSUE 3 | MAY2017

Alleycat Round

FHBL9965-

Hinged

gear

Alleycat Square

FHBL9065-

tray

Call [phone] email [e-mail] or visit www.fernhoward.comCall [phone] email [e-mail] or visit www.fernhoward.com

The light source contained in this luminaire shall only be replaced by
the manufacturer or his service agent or a similar qualied person.

Galaxy LED Bulkheads - Installation Instructions

1 3

5 7

2 4

6 8

Standard Wiring

Emergency Wiring

Screws

Not

Supplied

IP rating must be retained. An M20 IP65 cable gland must
be used. Any xing holes must be lled with a proprietary
silicon sealing compound.

9

ON

Green/

Blue

Neutral

Yellow

Earth

Brown

Live

~ 50/60Hz

Power Factor = 0.9pF

Supply Current = 220-240V

Blue

Neutral

Green/

Yellow

Earth

5-7mm

Permanent

2

0.5 - 1.5mm

Black

Live

2

Brown

Live

SUITABLE FOR LOOPING IN

Circuit Breaker Type No. of Products

C10 50
C13 65
C16 80
C20 100
B10 30
B13 39
B16 48
B20 60