Fellowes SB-95C User Manual
SB-95C
Please read these instructions before use.
Veuillez lire ce Mode d’emploi avant utilisation.
Favor de leer estas instrucciones antes del uso.
ENGLISH
FRANÇAIS
ESPAÑOL
A
L
E
D
M
B
E
F
J
H
I
C
K
2
Contents
Product Profile . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Set-Up . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
Supplies . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7
Limited Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7
Dear Customer,
Thank you for buying a Fellowes Shredder. We have
made many improvements in our shredder since its
introduction in 1982. We are confident that it offers
you the greatest value for your money in its product
category today. We hope it meets – or even exceeds –
your expectations.
To ensure years of safe, efficient use, please read these
few pages about your new shredder. If this manual
doesn’t answer all your questions or if you wish to
comment on this product, we welcome your call or letter.
Sincerely,
James Fellowes
Chairman & CEO
3
ENGLISH
Product Profile
This product is built to shred
paper, staples, small paper clips,
credit cards, CDs, and DVDs
(CDs and DVDs in designated
slot). It is not built to shred transparencies, adhesive labels,
newspaper, cardboard, large paper clips, or plastic (other than
items noted above). Attempting to shred items not intended for
this shredder may cause damage.
Confetti-cut
Sheet capacity* 17 sheets
CD/DVD capacity 1
Paper shred size 5/32" x 1 1/2" (3.9 x 38 mm)
Maximum paper width 9" (230 mm)
Recommended daily capacity 100-200 shredding passes
Maximum running time 20 minutes
Automatic cool-down period 30 minutes
Voltage 120V/60Hz/5.0A
*Based on 20 lb., 8-1/2" x 11" (75 gsm) paper with shredder operating at rated voltage; heavier paper, high humidity,
or other than rated voltage may reduce sheet capacity.
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING
While setting up shredder
•Check shredder for damage or defects; some paper particles in the basket are normal due to product testing and does not indicate a defect.
•If the cord is damaged do not replace cord or use the machine. Return machine for
a replacement.
•Avoid touching exposed blades on underside of confetti-cut shredder head.
•Plug power cord in an outlet that can easily be reached. The plug is the primary electrical disconnect.
•Make sure the electrical rating listed on the serial label (located inside, just below top
of shredder) matches the available electric power.
•Do not place shredder near or over a heat or water source.
While operating shredder
•Keep hands and hanging objects (jewelry, ties, loose clothing,
long hair, etc.) away from paper entry.
•Keep children and pets away from the shredder.
When not in use
•Always turn off and unplug shredder.
•Unplug before emptying basket.
•Do not open shredder head: Danger of electric shock.
Opening shredder head will void the warranty.
NOTE:
Do not use flammable synthetic oil, petroleum-based products
or aerosols of any kind on or near product at any time.
4
ENGLISH
Control Switch (E)
IAUTOMATIC
Turns on the automatic-start sensor
and the green
Ready light.
O OFF
Turns off the automatic-start sensor
and the green
Ready light.
R REVERSE
Runs shredder in
reverse mode.
Press and hold to
activate.
Troubleshooting Lights
Ready Light (F)
(Green)
Shredder is in
automatic start
mode.
Basket Ajar (H)
Waste basket
drawer is open.
Basket Full (H)
Waste basket is
full or paper has
collected under
cutting cylinders.
Paper Jam (I)
Shredder is
jammed (e.g.,
too much paper
fed at one
time).
Overheat Light
(J)
Shredder
requires a cool
down period.
For convenience and energy savings, your shredder is equipped with an
automatic-
start sensor (K)
. This means that when the control switch (E) is in the automatic [I]
position, the shredder will start running when paper is fed into it. The shredder stops a
few seconds after the paper has passed through.
CAUTION:
The automatic-start sensor cannot tell the difference
between paper and other objects. This feature can also be a hazard.
Always turn off the shredder when it is not in use. Unplug the shredder if it will not be used for an extended period.
To shred
Press control switch (E) to automatic [I] position. Green ready light (F) should turn on.
PAPER
•Feed paper straight into entry (C), releasing when shredder begins shredding; see
Product Profile for limits on paper width, shreddable items, sheet capacity, etc.
•Shred no more than 20 minutes; shredding longer will cause shredder to turn itself off
for 30 minutes to cool down.
•Press control switch to off [O] position after cutting has stopped.
Set-Up
•Pull waste basket drawer (A) completely out of cabinet.
•Put waste bag in basket (sample bags provided). Allow edges to overhang. Contact
Fellowes to order more bags. (Part #36053).
•Slide waste basket drawer (A) into cabinet. The shredder will not operate if drawer is
not pushed all the way into cabinet.
•Casters have been added for your convenience.
•Plug power cord into a convenient outlet.
Operation
Control Switches
E
F
J
H
I
5
ENGLISH
CDs, or DVDs
•Slide safety cover (L) to the right to expose the CD entry (M).
•Hold CD, or DVD at the edge and feed one at a time, straight into entry (M) releasing
when shredding begins. Shredder will stop when item has passed through entry. CDs
and DVDs will be shredded into small particles.
•Slide cover (L) to the left when done shredding media.
CAUTION:
Do not hold CD or DVD with finger through the center ring while feeding
into shredder.
To empty waste basket
If basket full light (H) is on, follow these steps until light turns off.
•Press control switch (E) to the off [O] position.
•Open the waste basket drawer (A) and remove full bag.
•Place new bag in basket, then slide drawer into cabinet (Fellowes plastic bag 36053).
•Press and hold control switch (E) in the reverse [R] position for a few seconds to clear
paper shreds that have collected under cutting cylinders.
•Alternate between automatic [I] and reverse [R] for a few seconds in each position.
CAUTION:
The shredder may be damaged if you alternate too rapidly between
automatic and reverse.
•Unplug shredder and remove wastebasket drawer (A).
– Carefully clear any paper shreds that have collected on under side of paper entry
(C).
CAUTION:
Confetti-cut shredders have exposed blades. Use care when remov-
ing paper shreds on underside of paper entry.
To clear a paper jam
If paper jam light (I) is on, follow these steps until light turns off.
•Check the waste basket and empty if full.
•Press and hold control switch (E) in the reverse [R] position to back paper out of paper
entry (C). Try pulling gently on paper to remove it from shredder.
•Alternate between automatic and reverse, if needed:
– Move control switch to automatic [I] and run for 1-2 seconds.
– Press and hold control switch (E) in the reverse [R] position for a few seconds.
– Continue alternating between automatic and reverse until the jam clears.
CAUTION:
The shredder may be damaged if you alternate too rapidly between
automatic and reverse.
Maintenance
Empty waste basket regularly
to ensure the smooth functioning of the cutting cylin-
ders. The shredder will not operate when the basket is full.
Oil regularly to ensure proper operation. If used at or near daily capacity, apply oil
every time you empty the basket. Use Fellowes Powershred Lubricant #35250 or
other non-aerosol vegetable-based oil in a long-nozzle container (sample oil
provided).
CAUTION:
Do not use flammable synthetic oil, petroleum-based products, or
aerosol lubricants of any kind.
To oil the cutting cylinders
•Apply oil over full width of cutting cylinders through the paper entry (C).
•Move control switch (E) to automatic [I] and run for 1-2 seconds.
•Press and hold the control switch (E) in reverse [R] for at least 3 seconds.
•Repeat the automatic/reverse sequence 3 or more times.
2
1
3
6
ENGLISH
Troubleshooting
If there is a problem with your shredder, check these symptoms and remedies. If you
cannot solve the problem, contact Fellowes customer service.
Do not open shredder
head
to attempt repair. You could be exposed to serious electric shock and will void the
warranty.
Symptom
Ready Light (F) will not light.
Shredder does not start or stops
while shredding.
Basket ajar/basket full
light (H) is on.
Paper jam light (I) is on.
Overheat light (J) turns on and
shredder will not operate.
Shredder sheet capacity decreases,
noise level increases, or cutting cylinders
stop with a squeak or rubbing sound.
Shredder runs for a few seconds after the
paper has cleared the cutters.
Remedy
Make sure shredder is plugged in and
the control switch (E) is in the automatic
[I] position.
• Make sure shredder is plugged in and
control switch (E) is in the automatic [I]
position.
• Shredder is jammed. Follow the
instructions under Operation.
Make sure the waste basket (A) is all the
way into the cabinet. Empty the waste
basket. Follow the instructions under
Operation.
Clear the paper jam. Follow the
instructions under Operation.
Wait 30 minutes for shredder to cool
down before trying again.
Oil the cutting cylinders. Follow the
instructions under Maintenance.
No action required. This is a self-cleaning
function.
Loading...