Safety Instructions
• Read and save these instructions.
• Follow all warnings and instructions marked on the product.
• Always turn off and unplug the machine before moving or 
cleaning.
• Operate shredder from the power source indicated on the serial 
label. If you are not sure of the type of power available, 
consult your dealer or a power company.
• Power cord should be easily accessible because it serves as the 
disconnect switch. If the power cord is damaged, call the 
number listed under 
Contact for Service.
• If the shredder does not come with a wastebasket, be certain 
the basket you select provides a stable base for the shredder. 
Tall or narrow baskets may be top heavy and unstable. 
• Keep loose objects (jewelry, ties, long hair) away from 
shredder.
• CAUTION: Do not insert aerosol cleaners or lubricants into or 
around the machine. Some agents may combust, causing 
serious injury.
• Empty wastebasket frequently.
• Do not place shredder near water, over a radiator or a heat 
register. 
• Do not rest anything on the power cord. Do not place machine 
where people will walk on the cord.
• The use of an extension cord is not recommended. 
• Do not service this product yourself. An opened cover may 
expose you to dangerous voltage points or other risks and will 
void manufacturer’s warranty. 
• Do not exceed recommended sheet capacity or usage. (See
Specifications).
• Do not shred continuous forms.
• Do not shred labels, transparencies, glossy paper, newsprint, 
plastic or cardboard.
• Keep out of the reach of children and pets.
• Never insert your hand or fingers into feed opening.
Installation
1. Interlock switch
As an added safety measure, this unit will not operate 
unless the tab on the upper right portion of the specially 
designed waste container has activated the interlock switch. 
The shredder will not operate if the interlock switch is not 
in the proper position or if the main unit is lifted off of the 
waste container. CAUTION:When moving the shredder, or 
after the main unit is removed to empty the waste 
container, always make sure that the interlock switch is 
properly set.
2. Be sure to use the specially designed waste container.
3. When shredder is positioned on basket, plug the power
cord into a standard AC outlet.
Operation
Prepare paper to be shredded. Do not exceed the recommended 
sheet capacity. (See 
Specifications)
1. Position paper over paper entry.
2. Slide main switch to the ON (
▼) position to activate the
standby mode.
3. Shredder automatically starts when paper is placed in the 
entry and stops when finished shredding.
Important Note:
If paper is wider than the entry and you 
fold it to fit, the paper thickness increases and the recommended 
capacity may be exceeded.
Oil the cutters
When...
• Every second or third time you empty the basket; 
• If the shredder’s cutting capacity is diminished;
• If the cutting cylinders stop with a squeak or a rubbing sound
after power is removed.
How...
Use Powershred Lubricant #35250 or a suitable alternative with 
an extension nozzle. Alternatives can be 3 in 1 or Sewing 
Machine Oil. Oil must be non-flammable material and a nondegreaser! Do not use a can spray. Accelerants are combustible. 
Squeeze the lubricant across the full width of the cutters and then 
turn the machine on and run the cutting system forward for a few 
seconds. 
Then, slide the main switch to the REVERSE (▲) position 
and run the cutting system for a few seconds. Repeat the 
procedure.
If a Jam Occurs
1. Immediately return power switch to OFF (I) position. 
2. Slide power switch to the REVERSE (▲) position until the
jammed paper has been fully removed from the cutter.
Power Jack
Switch
Housing
Wastebasket
Paper Entry
2