Fellowes CC4 User Manual

®

Models: S40C

P400C

CC4

Paper Shredder
Destructeur de documents
Destructora de documentos
Aktenvernichter
Papiervernietiger
Distruggi documenti

Operating Instructions
Mode d’emploi
Instrucciones de funcionamiento
Bedienungsanleitung
Bedieningsinstructies
Istruzioni sul funzionamento

Safety Instructions

• Read and save these instructions.

• Follow all warnings and instructions marked on the product.

• Unplug this product from the wall outlet before cleaning. The housing can be cleaned with a
cloth, dampened with a mild soap and water solution.

• Shredder should never be placed near or over a radiator, heat register or water.

• Operate shredder from the power source indicated on the serial label. If you are not sure
of the type of power available, consult your dealer or a power company.

• Do not rest anything on the power cord. Do not place machine where persons may walk
on the cord.

• If an extension cord is used, make sure that the total ampere ratings of the products plugged
into the extension cord do not exceed the extension cord ampere rating and that the total of
all products plugged into the wall outlet does not exceed 15 amperes.

• Power cord should be easily accessible because it serves as the disconnect switch. If the power
cord is damaged, call the number listed under “Contact for Service”.

• Do not service this product yourself. An opened cover may expose you to dangerous voltage
points or other risks, and will void manufacturer’s warranty.

• Keep loose objects (jewelry, ties, long hair) away from shredder.

• CAUTION: Do not insert aerosol cleaners or lubricants into or around the machine. Some agents
may combust, causing serious injury.

• Empty wastebasket frequently.

• Always turn off and unplug the machine before moving, cleaning or any other conduct other
than normal operation. Serious injury may result.

• Do not exceed recommended sheet capacity or usage. (See “Specifications”).

• Do not shred continuous forms.

• Do not shred labels, transparencies, glossy paper, newsprint, plastic or cardboard.

• This compact shredder is intended for paper only. Do not attempt to shred paper clips and
other hard materials as damage to the cutting system may result.

• Keep out of the reach of children and pets.

• Never insert your hand or fingers into feed opening.

• This shredder should be operated only with an operator in attendance.

Installation

• Use shredder only with basket provided

• Shredder must be seated towards rear of basket

• Tab in basket must make connection with slot in bottom of shredder

Duty Cycle:

3 minutes ON (I) and 10 minutes OFF

Operation

Prepare paper to be shredded. Remove staples and paper clips and make sure to feed no more
than the recommended sheet capacity at one time.

• Slide the main switch to the AUTOposition to activate the standby mode.

•The shredder automatically STARTS when paper is placed in entry and STOPSwhen finished
shredding.

Important Note: If paper is wider than the entry and you fold it to fit, the paper thickness increases
and the recommended capacity may be exceeded.

If the Paper Jams

Slide the switch to the REVERSE (R) position to clear the paper. Always unplug the unit before
attempting manual removal of paper.

If the RED LED is lit

If the red LED is lit, the machine isn’t properly sitting on the basket or the waste bin is full of paper.
If the waste bin is full of paper, empty it, and replace the head. If the waste bin is empty, refer to
illustrations.

Oil the cutters:

When...

• Every second or third time you empty the basket;

• If the shredder’s cutting capacity is diminished;

• If the cutting cylinders stop with a squeak or a rubbing sound after power is removed.

How...

Use Powershred Lubricant #35250 or a suitable alternative with an extension nozzle. Alternatives
can be 3 in 1 or Sewing Machine Oil. Oil must be non-flammable material and a non-degreaser! Do
not use a can spray. Accelerants are combustible.
Squeeze the lubricant across the full width of the cutters and then turn the machine on and run the
cutting system forward for a few seconds.
Then, depress the reverse button and run the cutting system for a few seconds. Repeat the

procedure.

Specifications:

Power Source: 120V-60Hz (N. America)
Power Cord: 6 Feet (1.9 meters)
Recommended Daily Use 50-75

* Sheet capacity measured with 20 lb., 8-

1

/2 x11” paper. Different paper weights and electrical

currents will affect capacity.

Overload Protection

This shredder is protected by a built-in thermal overload device that serves to protect the motor from
overuse. When continuous shredding is conducted for an extended period of time, the shredder will
automatically turn itself off to cool down. When shredding is automatically stopped, allow the unit
to stand for about 30 minutes before using it again.

Important Note

This paper shredder is not intended to shred high volumes of paper. Please refer to the
specifications for the recommended daily usage and sheet capacity of this shredder. Please note
that if the paper is wider than the entry, and you fold it to fit, the paper thickness increases and the
recommended capacity may be exceeded.

Limited Warranty

Fellowes Manufacturing Company warrants the cutting cylinders of all Fellowes shredders to be free from defects in
material and workmanship for 5 year from the date of purchase by the original consumer. Fellowes warrants all other
parts of the machine to be free of defects in material and workmanship for 1 year from the date of purchase by the
original consumer. If any part is found to be defective during the warrant period, your sole and exclusive remedy will
be repair or replacement, at Fellowes’ option and expense, of the defective part.
This warranty does not apply in cases of abuse, mishandling or unauthorized repair. ANY IMPLIED WARRANTY,
INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO
THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential or
incidental damages attributable to this product. This warranty gives you specific legal rights. You may have other legal
rights that vary from state to state.
For more detail or to obtain service under this warranty, please contact Fellowes Customer Service at 1-800-955-0959,
Monday through Friday, 8 AM - 5 PM (Central Standard Time).
For specific instructions on obtaining service under this warranty on machines purchased outside the USA, contact the
appropriate location listed in the Contact for Service section of this instruction manual.
Warrantor: Fellowes Manufacturing Company.

Declaration of Conformity

Fellowes Manufacturing Company

Doncaster Road, Kirk Sandall

Doncaster, South Yorkshire, DN31H England

declares that the product

Models S40C, P400C, CC4
conforms with the requirements of the Low Voltage Directive (73/23 EEC) and the Electromagnetic Compatibility
Directive (89/336 EEC) and the following harmonized European Normes (EN Standards) and IEC Standards.

Safety: EN60950 ‘Information Technology Equipment’
EMC: Performance

Standar

d Severity Level Criteria

EN 55014-2:1997 Category I device NA
EN 55014-1:1993 Household limits NA
+A1:1997
EN 61000-3-2:1995 Class A NA
EN 61000-3-3:1995 Section 5 NA

Itasca, Illinois, USA _____________________
April 25, 2000 Anthony Storrie

Figure A

Sheet Entry Shredding Shred

Capacity Width Speed Size Dimensions Weight

S40C 4 9-

1

/2” 12 fpm7/32 x 1-1/2” 14-1/2 x 13-1/2 x 6-3/4”9 lbs.

240mm 3.7mpm 5.8 x 38mm 368 x 343 x 172mm 4.1kg

P400C 4 9-

1

/2

” 12 fpm

7

/32

x 1-

1

/2

” 14-

1

/2

x 13-

1

/2

x 6-

3

/4

”9 lbs.

240mm 3.7mpm 5.8 x 38mm 368 x 343 x 172mm 4.1kg

I=Auto
O=Off
R=Reverse