Feiss WB1323 User Manual
ASSEMBLY INSTRUCTIONS FOR VS12102, VS12103, WB1323
(E) 4/07
Outlet Box
Ground Wire
Mounting Plate
Supply
FIG. 2
Supply
Wire
Head less Screw
Ring
Shade
Fixture Ground Wire
Fixture
Plate
Fixture Wire
Hex Key
FIG. 1
Bulb
(not included)
Spacer Tube
Socket
Wrench
Counter
Ring
IMPORTANT:
TURN OFF POWER AT MAIN FUSE OR
CIRCUIT BREAKER BOX BEFORE
STARTING INSTALLATION
Carefully unpack and identify all parts
before assembly. Bulb not included.
1. Install mounting plate (see fig. 1):
A. Take supply wires from outlet box and
carefully pass them through center hole of
mounting plate. Note: the flat surface of
mounting plate must face the outlet box and the
angled rim side facing toward you.
B. Install mounting plate onto the outlet box
using two screws supplied with outlet box.
C. Spread electrical wires so that black wires
are on one side of the outlet box and the white
wires are on the other side.
2. Connect electrical wires (see fig. 1):
A. Connect fixture wires (with plastic insula-
tion):
Connect fixture wire without tracer (round and
smooth) to black (or red) supply wire. ConÂnect fixture wire with tracer (square and ridged)
to white supply wire. Wrap with electrical tape
to secure wire connector and wires together.
B. Connect ground wire:
Connect fixture ground wire to supply ground
wire (usually with green insulation) with wire
connector. Note: If there is no supply ground
wire at outlet box then attach fixture ground
wire securely onto green grounding screw
located at mounting plate. See fig. 2.
IMPORTANT: Never connect ground wire to
black or white supply wires.
3. Install fixture plate (see fig. 1):
While carefully tucking all electrical wires
inside of fixture plate, install the fixture plate
onto the mounting plate by fastening with a
head less screw. Use provided hex key to
tighten.
4. Install glass shade onto fitter and lock into
position by installing the spacer tube and
counter ring back onto the socket. Use
supplied wrench to tighten. Do not over
tighten.
Fixture Plate
Head less Screw
Hex Key
5. Install light bulb (not included). See relamping
label at socket area for type and maximum
allowed wattage.
6. Install ring by placing on end of glass shade. If
preferred, you have the option of not installing
the rings.
Loading...