Feiss VS2300 User Manual

Assembly Instructions For

1 2

VS23001, VS23002, VS23003, VS23004

IMPORTANT

TURN OFF THE POWER AT THE MAIN FUSE OR

CIRCUIT BREAKER BOX

BEFORE STARTING INSTALLATION

Carefully unpack and identify all parts before

assembly. Bulbs not included.

1. Install mounting plate :
A. Take supply wires from outlet box and

carefully pass them through center hole of
mounting plate. Note: The flat surface of
mounting plate must face the outlet box and
the angled rim side facing toward you.

B. Install mounting plate onto the outlet box

using two screws supplied with outlet box.

C. Spread electrical wires so that black wires

are on one side of the outlet box and the white
wires are on the other side.

3

4

2. Connect electrical wires :
A. Connect white fixture wire(s) to white

supply wire from outlet box with wire
connector. Connect black fixture wire(s) to
black supply wire from outlet box with wire
connector.

NOTE: Black outlet box wire may be red, round

and smooth and/or have copper conductor.
White outlet box wire may be square and
ridged and/or have a silver conductor.

B. Connect fixture ground wire (without plastic

insulation) to ground wire from outlet box
(usually with green insulation) with wire
connector.

Note: If there is no supply ground wire at

outlet box then attach fixture ground wire
securely onto green grounding screw located at
mounting plate.

IMPORTANT: Never connect ground wire to

black or white supply wires (from outlet box).

(E) 5/2012

3. Install fixture plate. While carefully tucking all
electrical wires inside of fixture plate, install
the fixture plate onto the mounting plate by
fastening with set screw. Use an allen key to
tighten.

4. Install shade onto fitters by fastening with

5

counter ring.

5. Install light bulb (not included). See relamping
label at socket area for type and maximum
allowed wattage.