Assembly Instructions For
1 2
VS19201, VS19202, VS19203
IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR
5
Carefully unpack and identify all parts before
1. Install mounting plate :
A. Take supply wires from outlet box and
B. Install mounting plate onto the outlet box
C. Spread electrical wires so that black wires
2. Connect electrical wires :
A. Connect white fixture wire(s) to white
4
NOTE: Black outlet box wire may be red, round
B. Connect fixture ground wire (without plastic
Note: If there is no supply ground wire at
IMPORTANT: Never connect ground wire to
BEFORE STARTING INSTALLATION
assembly. Bulbs not included.
carefully pass them through center hole of
mounting plate. Note: The flat surface of
mounting plate must face the outlet box and
the angled rim side facing toward you.
using two screws supplied with outlet box.
are on one side of the outlet box and the white
wires are on the other side.
supply wire from outlet box with wire
connector. Connect black fixture wire(s) to
black supply wire from outlet box with wire
connector.
and smooth and/or have copper conductor.
White outlet box wire may be square and
ridged and/or have a silver conductor.
insulation) to ground wire from outlet box
(usually with green insulation) with wire
connector.
outlet box then attach fixture ground wire
securely onto green grounding screw located at
mounting plate.
black or white supply wires (from outlet box).
CIRCUIT BREAKER BOX
(E) 11/11
3. Install fixture plate. While carefully tucking all
electrical wires inside of fixture plate, install
the fixture plate onto the mounting plate by
fastening with set screw. Use an allen key to
tighten.
3
4. Install shade onto fitters by fastening with
spacer and counter ring.
5. Install light bulb (not included). See relamping
label at socket area for type and maximum
allowed wattage.
Loading...