Assembly Instructions For
Outlet Box
Mounting Plate
FIG. 2
Supply
Ground Wire
Supply
Wire
Head less Screw
Fixture Ground Wire
Fixture Wire
Hex Key
Shade
5
Fixture
Plate
VS14503
TURN OFF THE POWER AT THE MAIN FUSE OR
Carefully unpack and identify all parts before assembly.
1. Install mounting plate (see fig. 1):
A. Take supply wires from outlet box and carefully pass
B. Install mounting plate onto the outlet box using two
C. Spread electrical wires so that black wires are on
FIG. 1
2. Connect electrical wires (see fig. 1):
A. Connect fixture wires (with plastic insulation)
B. Connect ground wire: Connect fixture ground wire
IMPORTANT: Never connect ground wire to black or
(E) 10/08
IMPORTANT
CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Bulb not included.
them through center hole of mounting plate. Note: the
flat surface of mounting plate must face the outlet box
and the angled rim side facing toward you.
screws supplied with outlet box.
one side of the outlet box and the white wires are on
the other side.
Connect fixture wire without tracer (round and
smooth) to black (or red) supply wire. Connect fixture
wire with tracer (square and ridged) to white supply
wire. Wrap with electrical tape to secure wire
connector and wires together.
to supply ground wire (usually with green insulation)
with wire connector. Note: If there is no supply ground
wire at outlet box then attach fixture ground wire
securely onto green grounding screw located at
mounting plate. See fig. 2.
white supply wires.
Fixture
Plate
1
2
3
4
Bulb
(not included)
Hex Key
(supplied)
Glass Dome
Socket
Fitter
Headless Screw
3. Install fixture plate (see fig. 1): While carefully tucking
all electrical wires inside of fixture plate, install the
fixture plate onto the mounting plate by fastening with
a head less screw. Use provided hex key to tighten.
4. A. Install bulb (not included). See relamping label
located near socket area for type and maximum
allowed wattage.
NOTE: Make certain not to handle lamp with bare
hand since this will cause lamp to shatter at high heat.
Handle with clean soft cloth.
B. Install glass dome by screwing onto socket.
5. Install shade by sliding into slot in fitter.
Loading...