Feiss SF246 User Manual

Assembly Instructions For

Flat Washer

Ball Cap Nut

Center Column

Socket

Long
Threaded Pipe

SF246

(E) 10/07

4

IMPORTANT

TURN OFF THE POWER AT THE MAIN FUSE OR

Short Screw

Lock Washer

Canopy
(Fixture Plate)

BEFORE STARTING INSTALLATION

Carefully unpack and identify all parts before assembly.

Bulbs not included.

1. Install Center Column by screwing securely into fixture
plate.

CIRCUIT BREAKER BOX

1

Arm

2

Center Plate

Bulb
(not included)

5

3

2. A. Take one arm and insert bottom section of arm into
a hole in center plate. Then fasten top section of arm
onto canopy using flat washer, lock washer, and short
screws.

B. Repeat other arms.
C. Make certain arms are aligned straight. If not, while

holding onto center plate turn canopy until they are
aligned.

3. Screw the long threaded pipe into coupler located at
bottom of socket assembly. Note correct position of
threaded pipe at illustration.

4. Follow enclosed “Multiple Standard Installation
Instructions” for electrical and fixture installation onto
ceiling outlet box.

5. Install bulbs (not included). See relamping label located
at socket area for type and maximum allowed wattage.

6. Slide glass shade through the long threaded pipe till it
rests onto bottom section of arms. Secure in position
by fastening with a washer and a hex nut. Do not over
tighten.

7. Slip cap and fasten finial onto threaded pipe.

Shade

6

7

Washer
Hex Nut

Cap

Finial