Feiss SF238 User Manual

ASSEMBLY INSTRUCTIONS FOR SF238, SF239

(E) 4/07

Mounting Plate

Small

Lock Washer

Threaded Pipe

Socket
Assembly

Center
Column

Mounting Screws

Screw
(short length)

Fixture Plate

Ball Cap Nuts

Arm

Bulb
(not included)

TURN OFF THE POWER AT THE MAIN FUSE

IMPORTANT

OR CIRCUIT BREAKER BOX

BEFORE STARTING INSTALLATION

Carefully unpack and identify all parts

before assembly. Bulbs are not
included.

1. Take fixture wire and ground wire

exitingabove center column and thread

through, fixture plate, lock washer and

hex nut.Lock all together by tightening
hex nut.

2. Install upper section of arms onto

fixtureplate by fastening with screw
(short) andsmall hex nut.

3. Install a hex nut onto one end of long

threaded stud leaving about 3/8" (10

mm) thread exposed. Screw same end
of threaded stud into bottom of socket
assembly. Tighten hex nut.

4. Follow enclosed supplement
installation instructions for electrical
and fixture installation onto house

outlet box. If you do not have an outlet

box at desired location to attach the
fixture than hire a qualified electrician
to create one.

Pan

5. Install light bulbs (not included). See

relamping label located near socket

area for type and maximun allowed
wattage.

Flat Washer

Hex Nut

Cover

Finial

Shade

6. Sit decorative pan on top of glass shade.

Then while holding securely onto the
glass shade, slide through the installed
threaded pipe until pan touches bottom
end of arms. Secure into position by
fastening with a flat washer and hex

nut. Afterward, slip cover and install

finial by screwing onto protruding
threaded pipe.