Page 1
Assembly Instructions For
P1205
32
10"
1
(E) 12/09
16"
22"
28"
34"
40"
TURN OFF THE POWER AT THE MAIN FUSE OR
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly. Bulb
not included.
1. STEM HUNG INSTALLATION:
A. Choose desired installation height from dimensions
shown in above diagram. Thread fixture wires through each
stems to be used. Note correct position of stems from left
diagram. Screw all stem together until secure. Screw bottom
stem into fixture coupler until secure.
B. Thread fixture wires from top stem through canopy. Install
top end of stem assembly by screwing into canopy.
WITHOUT STEM INSTALLATION:
A. Thread fixture wires from top of fitter through canopy.
Then screw canopy on top of fitter.
2. Cut excess wires leaving only 6" (15 cm) length of wires
above canopy. Split fixture wire into two strands. Then strip
off 3/4"(19 mm) of outer plastic insulation.
4
3. Follow enclosed supplement installation instructions for
electrical and fixture installation onto house outlet box. If
you do not have an outlet box at desired location to attach
the fixture then hire a qualified electrician to create one.
4. Install glass shade onto fitter by fastening with spacer tube
and counter ring. Use provided wrench to tighten.
IMPORTANT
CIRCUIT BREAKER BOX
46"
52"
5. Install bulb (not included). See relamping label located near
socket area for type and maximum allowed wattage.
5
Loading...