Feiss P1153 User Manual
Assembly Instructions For
P1153
(E) 12/08
2
Swivel
Plastic Ring
Canopy
(Fixture Plate)
1
Stems
Fixture Wires
Socket
9"
15"
21"
27"
33"
39"
45"
51"
3
Spacer Ring
Counter Ring
4
Bulb
(not included)
Shade
TURN OFF THE POWER AT THE MAIN FUSE OR
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly. Bulb not
included.
1. Install stems:
A. Choose desired installation height from dimensions shown in
above diagram. Thread fixture wires through each stems to be
used. Note correct position of stems from left diagram. Screw all
stem together until secure.
B. Install bottom end of stem assembly by screwing into top of
fixture.
C. Thread fixture wires through canopy, plastic ring and then
swivel. Allow canopy to carefully slide down without scraping the
surface of stems. Then install swivel by screwing onto top end of
stem assembly.
2. Follow enclosed supplement installation instructions for electrical
and fixture installation onto house outlet box. If you do not have
an outlet box at desired location to attach the fixture than hire a
qualified electrician to create one.
3. Install glass shade onto socket by fastening with spacer ring (open
side facing up) and counter ring.
4. Install bulb (not included). See relamping label located near
socket area for type and maximum allowed wattage.
IMPORTANT
CIRCUIT BREAKER BOX
Loading...