Feiss P1147 User Manual

Assembly Instructions For

P1147

(E) 4/08

2

Swivel

17-1/2"

Canopy
(fixture plate)

Cap Nut

1

Stem

Fixture Wires

Fixture

23-1/2"

29-1/2"

35-1/2"

41-1/2"

47-1/2"

53-1/2"

59-1/2"

IMPORTANT

TURN OFF THE POWER AT THE MAIN FUSE OR CIRCUIT BREAKER

BOX BEFORE STARTING INSTALLATION

Carefully unpack and identify all parts before assembly. Bulb not included.

3C

3A

3B

Socket

Shade

1. Install stems:
A. Choose desired installation height from dimensions shown in above diagram.

Thread fixture wires through each stems to be used. Note correct position of stems

from left diagram. Screw all stem together until secure.
B. Install bottom end of stem assembly by screwing into top of fixture.
C. Thread fixture wires through canopy and then swivel. Allow canopy to carefully

slide down without scraping the surface of stems. Then install swivel by screwing

onto top end of stem assembly.

2. Follow enclosed supplement installation instructions for electrical and fixture

installation onto house outlet box. If you do not have an outlet box at desired

location to attach the fixture than hire a qualified electrician to create one.

3. A. Install shade onto fitter by fastening with check ring and counter ring.
B. Install bulb (not included). See relamping label located near socket area for type

and maximum allowed wattage.
C. Place glass plate inside of lower ring.
D. Install lower ring onto shade by fastening with cap nut (decorative), from below.

Check Ring

Counter
Ring

Bulb
(not included)

Glass Plate

3D

Lower Ring

Cap Nut
(Decorative)