Assembly Instructions For
Canopy
(Fixture Plate)
Cap Nuts
Swivel
Stems
2
P1137
8-1/4"
14-1/4"
1
Socket
(E) 4/08
20-1/4"
26-1/4"
32-1/4"
38-1/4"
44-1/4"
50-1/4"
Bulb
3
4
5
(not included)
Glass Dome
Thumb Screw
Harp
Metal Ring
Shade
Metal Ring
TURN OFF THE POWER AT THE MAIN FUSE OR
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly.
Bulb not included.
1. Install stems:
A. Choose desired installation height from dimensions shown in
above diagram. Thread fixture wires through each stems to be
used. Note correct position of stems from left diagram. Screw all
stem together until secure.
B. Pass fixture wires through swivel in canopy and screw top end
of stem assembly into swivel.
2. Follow enclosed supplement installation instructions for electrical
and fixture installation onto house outlet box. If you do not have
an outlet box at desired location to attach the fixture than hire a
qualified electrician to create one.
3. A. Install bulb (not included). See relamping label located near
socket area for type and maximum allowed wattage.
NOTE: Make certain not to handle lamp with bare hand since this
will cause lamp to shatter at high heat. Handle with clean soft
cloth.
B. Install glass dome by screwing onto socket.
4. Install harp by securely fastening with thumb screws.
5. A. Place metal ring onto glass plate. Then place shade. And then
place another ring on top of shade.
B. While holding firmly onto glass plate, install the assembled
parts onto harp by fastening with finial.
IMPORTANT
CIRCUIT BREAKER BOX
Glass Plate
Finial
Loading...