Feiss OL8408 User Manual

Assembly Instructions For

OL8408

5

TURN OFF THE POWER AT THE MAIN FUSE

Carefully unpack and identify all parts before

assembly. Bulb not included.

(E) 12/11

IIMPORTANT

OR CIRCUIT BREAKER BOX

BEFORE STARTING INSTALLATION

4

1. Electrical installation onto post (not
supplied): If you are replacing an existing
fixture, disconnect and remove the old
fixture.

A) Slip post cup over post. Mark position of

3

2

holes in post cup on post.

B) Remove post cup and expose the supply

wiring from above post. Drill and tap a screw
hole for the provided screw.

C) Connect white fixture wire to white supply

wire from post with wire connector. Connect
black fixture wire to black supply wire from
post with wire connector.

NOTE: Black wire from post may be red,

round and smooth and/or have copper
conductor. White wire from post may be
square and ridged and/or have a silver
conductor.

1F

1C1A1D

1B

D) Connect fixture ground wire (without

plastic insulation) to ground wire from post
(usually with green insulation) with wire
connector.

IMPORTANT: Never connect ground wire to

black or white supply wires.

E) Tuck all wires inside of post.

F) Slip post cup onto post. Align holes in

post cup with holes in post. Secure them
together by fastening with machine screws
(enclosed).

2. Install the glass shade into the main frame
using the tabs and screws.

3. Install light bulb (not included). See
relamping label at socket area for type and
maximum allowed wattage.

4. Install the top cover onto the main frame
using the cap nuts and washers.

5. Install the fixture loop and cap on top of the

cover.