Feiss OL8108 User Manual

Assembly Instructions For
OL8108
TURN OFF THE POWER AT THE MAIN FUSE
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before
assembly. Bulb not included.
1. Electrical installation onto post (not supplied): If you are replacing an existing fixture, disconnect and remove the old fixture.
A) Slip post cup over post. Mark position of
holes in post cup on post.
B) Remove post cup and expose the supply wiring
from above post. Drill and tap a screw hole for the provided screw.
C) Connect white fixture wire to white supply wire
from post with wire connector. Connect black fixture wire to black supply wire from post with wire connector.
NOTE: Black wire from post may be red, round
and smooth and/or have copper conductor. White wire from post may be square and ridged and/or have a silver conductor.
(E) 12/11
IMPORTANT
OR CIRCUIT BREAKER BOX
3
2
1F
1C1A1D
D) Connect fixture ground wire (without plastic
insulation) to ground wire from post (usually with green insulation) with wire connector.
IMPORTANT: Never connect ground wire to black
or white supply wires.
E) Tuck all wires inside of post.
F) Slip post cup onto post. Align holes in post cup
with holes in post. Secure them together by fastening with machine screws (enclosed).
2. Install light bulb (not included). See relamping label at socket area for type and maximum allowed wattage.
3. Install the bottom cover onto the main frame and fasten with screws.
4. Install the fixture loop on top of the cover.
Loading...