Feiss OL7507 User Manual

Assembly Instructions For

OL7507

3

2A

2C

2B 2B

(E) 5/09

IMPORTANT

TURN OFF THE POWER AT THE MAIN FUSE OR

CIRCUIT BREAKER BOX

BEFORE STARTING INSTALLATION

Carefully unpack and identify all parts before assembly.

Bulb not included.

1. Gently slip shade inside of lantern until it securely sits
inside of bottom ring.

2. A. Install bridge onto top of lantern by fastening with
lock washer and short machine screw.

B. Swing the bridge aside.
C. Install light bulb (not included). See relamping label

at socket area for type and maximum allowed wattage.

D. Swing back the bridge until it hooks onto screw.

3. Install cover on top of lantern by fastening with rubber
washer and finial.

4. Electrical installation onto post: If you are replacing an
existing fixture, disconnect and remove the old fixture.

1

A) Slip post cup over post. Mark position of holes in

post cup on post.

B) Remove post cup and expose the supply wiring

from above post. Drill 1/8" (3mm) diameter pilot holes
in post at places where marked.

C) Connect white fixture wire to white supply wire

from post with wire connector. Connect black fixture
wire to black supply wire from post with wire
connector.

NOTE: Black wire from post may be red, round and

smooth and/or have copper conductor. White wire
from post may be square and ridged and/or have a
silver conductor.

D) Connect fixture ground wire (without plastic

insulation) to ground wire from post (usually with
green insulation) with wire connector.

IMPORTANT: Never connect ground wire to black or

white supply wires.

E) Tuck all wires inside of post.
F) Slip post cup onto post. Align holes in post cup

with holes in post. Secure them together by fastening
with sheet metal screws.

4F

4D

4C

4A 4B