Feiss OL7407 User Manual

Assembly Instructions For

1C

1B

1A

4F

4D

OL7407

TURN OFF THE POWER AT THE MAIN FUSE OR

Carefully unpack and identify all parts before assembly.

1. Lift latch to open door.

2. A. Slip candle tube over socket.
B. Install candle follower over candle tube.
C. Install type-B, candelabra base, of 60 Watt maximum

3. Close door.

1

3

4. Electrical installation onto post: If you are replacing an

A) Slip post cup over post. Mark position of holes in

B) Remove post cup and expose the supply wiring

C) Connect white fixture wire to white supply wire

NOTE: Black wire from post may be red, round and

D) Connect fixture ground wire (without plastic

IMPORTANT: Never connect ground wire to black

E) Tuck all wires inside of post.
F) Slip post cup onto post. Align holes in post cup

(E) 5/09

IMPORTANT

CIRCUIT BREAKER BOX

BEFORE STARTING INSTALLATION

Bulbs not included.

bulbs (not included).

existing fixture, disconnect and remove the old fixture.

post cup on post.

from above post. Drill 1/8" (3mm) diameter pilot holes
in post at places where marked.

from post with wire connector. Connect black fixture
wire to black supply wire from post with wire
connector.

smooth and/or have copper conductor. White wire
from post may be square and ridged and/or have a
silver conductor.

insulation) to ground wire from post (usually with
green insulation) with wire connector.

or white supply wires.

with holes in post. Secure them together by fastening
with sheet metal screws.

4C

4A 4B