Feiss MR1106 User Manual

Assembly Instructions For

Required

Extra

Crystal Glass

X4

1

Extra PIN

Qty.

X1

X1

PIN PART

MR1106

PIN

DESCRIPTION

Small S- Hook

Head Pin

Lock Washer & Hex Nut

(E) 5/10

Assembly

Detail:

Holding Rod

Machine Screws

Cover

U-channel

Carefully unpack and identify all parts before assembly.

Frame
Holding Rod

U-Channel

Glass Mirror

1. Lay glass mirror, with u-channels facing up, on a
non-abrasive and elevated surface.

2. Lay frame on top of glass mirror by aligning frame holding
rods into notches in u-channels. Make certain glass mirror
is centered within frame.

3. Lock holding rods into u-channel by attaching cover and
then fastening with machine screws (from inner-side of
u-channel) and lock washer and hex nut (from outer-side
of u-channel). See assembly detail graphic.

4. Hang all crystal glass parts as shown on drawing.

5. WALL MOUNTING: Requires two 30lbs. or over capacity
picture frame hangers or hooks (not included). Screws are
not recommended.

A. Decide desired wall location to hang mirror.

B. Install 2 picture frame hangers or hooks (not included)

on wall with approximately 14" distance to each other at
location corresponding with upper holding rod.