Feiss MR1044 User Manual

Assembly Instructions For

Frame

Glass Mirror

Spacer Tube

Mirror Bracket

MR1044

Screw

Mounting
Bracket

(E) 3/11

Carefully unpack and identify all parts before assembly.

1. Assemble mirror (see fig. 1):
A. Lay frame, with screw holes side facing up, on a

non-abrasive surface.

B. Gently lay glass mirror, with metal mirror brackets

side facing up, on top of frame. Holes in mirror
brackets must align with holes in frame.

C. Secure glass mirror onto frame with screw and

spacer tube at top and another set at bottom as shown
in diagram.

2. Mount onto wall (see fig. 2):
A. Upon deciding location to hang the mirror, test

install the wall-mounting bracket onto wall. Note:
Wall-mounting bracket must be located at
corresponding position with mounting bracket on the
mirror. See diagram for correct position of mounting
bracket and wall-mounting bracket.

B. Using a pencil, mark onto wall the two holes in

wall-mounting bracket. Then remove wall-mounting
bracket. Note: Make certain the two marked holes
are aligned horizontally to each other. Suggest using a
leveler.

WOOD WALL or
MANSONRY WALL or
TILE ON MANSONRY
WALL INSTALLATION:

Mounting
Bracket

Wall-Mounting
Bracket

Fig. 1

C. Dry Wall or Tile on Dry Wall Installation: Pre-drill

holes using 3/8" drill bit. (Tile on dry wall installation
requires 3/8" masonry drill bit)

Wood Wall Installation: Pre-drill holes using 1/8" drill

bit.

Masonry Wall or Tile on Masonry Wall Installation: Pre

drill holes using 3/16" masonry drill bit.

D. Dry Wall or Tile on Dry Wall Installation: Insert

machine screws through holes in wall-mounting
bracket. Thread butterfly anchors into machine screws
as shown in diagram. Pinch together the opposite ends
of butterfly anchors and push into predrilled 3/8" holes
until anchors spring open inside of wall. While pulling
wall-mounting bracket away from wall, tighten screws
using a screw driver.

Wood Wall Installation: Insert sheet metal screws thru

two holes in wall-mounting bracket. Fasten screws
directly into predrilled 1/8" holes.

Masonry or Tile on Masonry Wall Installation: Insert

plastic anchors into pre-drilled 3/16" holes. Insert
sheet metal screws through two holes in wall-mounting
bracket. Fasten screws into plastic anchors.

E. Mount mirror by hooking onto the installed

wall-mounting bracket.

DRY WALL or
TILE ON DRY WALL INSTALLATION:

Fig. 2