Feiss FM370 User Manual
Assembly Instructions For
1 2
FM370
3
5
6
4
(E) 5/22/2012
IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before
assembly. Bulbs not included.
1. Install mounting strap:
A. Gently pull supply wires out from outlet
box.
B. Install mounting strap onto the outlet box
using two screws supplied with outlet box.
NOTE: The side with green grounding screw
head must face away from the outlet box.
C. Spread electrical wires so that black wires
are on one side of the outlet box and the white
wires are on the other side.
2. Connect electrical wires:
A. Connect white fixture wire(s) to white
supply wire from outlet box with wire
connector. Connect black fixture wire(s) to
black supply wire from outlet box with wire
connector.
NOTE: Black outlet box wire may be red, round
and smooth and/or have copper conductor.
White outlet box wire may be square and
ridged and/or have a silver conductor.
B. Connect fixture ground wire (without
plastic insulation) to ground wire from outlet
box (usually with green insulation) with wire
connector.
Note: If there is no supply ground wire at
outlet box then attach fixture ground wire
securely onto green grounding screw located
at mounting strap.
IMPORTANT: Never connect ground wire to
black or white supply wires (from outlet box).
3. Partially thread the two pan mounting screws
into the mounting strap. Place the pan over
the pan mounting screws through the key
holes and twist the pan to lock in position.
Then tighten the pan mounting screws until
secure so the pan is flush with the ceiling.
7
4. Install light bulb (not included). See
relamping label at socket area for type and
maximum allowed wattage.
5. Screw the long threaded pipe into coupler
located at bottom of socket assembly. Note
correct position of threaded pipe at
illustration.
6. Slip shade through the threaded pipe until it
rests onto the bottom section of the pan. Then
secure into position by fastening with flat
washer and hex nut.
7. Install cover by fastening with finial.
Loading...