Feiss FM369 User Manual

Assembly Instructions For

FM369

Carefully unpack and identify all parts before

1

2

3

5A

4

5B

6

1. Install mounting strap:
A. Gently pull supply wires out from outlet box.
B. Install mounting strap onto the outlet box using

C. Install threaded pipe by screwing onto center of

D. Test install fixture plate to make certain about

E. Spread electrical wires so that black wires are on

2. Connect electrical wires:
A. Connect white fixture wire(s) to white supply wire

NOTE: Black outlet box wire may be red, round and

B. Connect fixture ground wire (without plastic

Note: If there is no supply ground wire at outlet box

IMPORTANT: Never connect ground wire to black or

(E) 1/12

IMPORTANT

TURN OFF THE POWER AT THE MAIN FUSE OR

CIRCUIT BREAKER BOX

BEFORE STARTING INSTALLATION

assembly. Bulbs not included.

two screws supplied with outlet box. NOTE: The side
with green grounding screw head must face away
from the outlet box.

mounting strap.

3/8” (8mm) of thread protrude outside of fixture
plate. If not then remove fixture plate and adjust
threaded pipe length accordingly. Secure threaded
pipe length by fastening with hex nut. Make certain
not to spin pipe during fastening. Place fixture plate
aside.

one side of the outlet box and the white wires are on
the other side.

from outlet box with wire connector. Connect black
fixture wire(s) to black supply wire from outlet box
with wire connector.

smooth and/or have copper conductor. White outlet
box wire may be square and ridged and/or have a
silver conductor.

insulation) to ground wire from outlet box (usually
with green insulation) with wire connector.

then attach fixture ground wire securely onto green
grounding screw located at mounting strap.

white supply wires (from outlet box).

3. Install fixture plate. While carefully tucking all
electrical wires inside of fixture plate, install the
fixture plate onto the mounting strap by fastening
with hex nut and then cap nut.

4. Install light bulb (not included). See relamping label
at socket area for type and maximum allowed
wattage.

5. A. Screw the long threaded pipe into coupler located
at bottom of socket assembly. Note correct position
of threaded pipe at illustration.

B. Slip shade through the threaded pipe until it

securely checks into bottom of fixture plate. Then
secure into position by fastening with washer, hex
nut, cap and finial. IMPORTANT: DO NOT OVER
TIGHTEN.

6. Then secure ring onto fixture plate by fastening with

cap nuts.