Assembly Instructions For
FM354
TURN OFF THE POWER AT THE MAIN FUSE OR
Carefully unpack and identify all parts before assembly.
1
2
3
1. Install mounting plate:
A. Fasten two long machine screws (supplied) into
B. Take supply wires from outlet box and carefully pass
C. Install mounting plate onto the outlet box using two
D. Test install fixture plate to make certain about 1/4”
E. Spread electrical wires so that black wires are on one
(E) 5/10
IMPORTANT
CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Bulbs not included.
opposite side of the mounting plate from green
grounding screw head.
them through center hole of mounting plate.
screws supplied with outlet box.
(5mm) of screws thread protrude outside of fixture
plate. If not then remove fixture plate and adjust screws
length accordingly. Secure screws length by fastening
with two hex nuts. Make certain not to spin screws
during fastening. Place fixture plate aside.
side of the outlet box and the white wires are on the
other side.
4
6A
6B
6C
5
2. Connect electrical wires:
A. Connect white fixture wire to white supply wire
from outlet box with wire connector. Connect black
fixture wire to black supply wire from outlet box with
wire connector.
NOTE: Black outlet box wire may be red, round and
smooth and/or have copper conductor. White outlet
box wire may be square and ridged and/or have a silver
conductor.
B. Connect fixture ground wire (without plastic
insulation) to ground wire from outlet box (usually with
green insulation) with wire connector.
Note: If there is no supply ground wire at outlet box
then attach fixture ground wire securely onto green
grounding screw located at mounting plate.
IMPORTANT: Never connect ground wire to black or
white supply wires (from outlet box).
3. Install fixture plate. While carefully tucking all electrical
wires inside of fixture plate, install the fixture plate onto
the mounting plate by fastening with two cap nuts.
4. Install center pipe by screwing into bottom of socket
assembly. Note correct position of center pipe at
illustration.
5. Install bulb (not included). See relamping label located at
socket area for type and maximum allowed wattage.
6. A. Slide cup, open side facing down, and shade through
the threaded pipe until shade comes to a stop.
B. Secure shade into position by fastening with a
washer and a hex nut. IMPORTANT: DO NOT OVER
TIGHTEN.
C. Slip cover and secure by fastening finial.
Loading...