Feiss FM313 User Manual

Page 1
Assembly Instructions For
Outlet Box
Mounting Bar
Outlet Box Mounting Screw
Bulb (not included)
Supply Ground Wire
Supply Wire
Fixture Ground Wire
Socket
Lock Washer
Coupler
Center Pipe
FM313
Carefully unpack and identify all parts before assembly. Bulb
Fixture Wire
Main Frame
1. Attach mounting bar securely to ceiling junction box with
2. Fasten one hex nut about 3/4" (19 mm) down from one end
3. Spread the electrical wires so that the black wires are on one
4. Electrical connections: Connect the white wire from the fixture to the white wire of
Connect the black wire from the fixture to the black wire of
NOTE: Black outlet box wire may be red, round & smooth
(E) 12/08
IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
not included.
two machine screws (supplied with junction box) through slot at each end of mounting bar. Note: mounting bar should be installed with "GND" imprint and/or two dimples facing down.
of threaded pipe. Then screw same end of threaded pipe into center hole in mounting bar. At this point test install the main frame onto ceiling through this threaded pipe and make certain 3/8" (10 mm) of pipe protrude below. If not, then adjust the threaded pipe location by screwing up or down accordingly. Once correct threaded pipe location has been adjusted, remove main frame and tighten hex nut against mounting bar. Make certain not to spin threaded pipe during tightening.
side of the outlet box and the white wires are on the other side.
the outlet box.
the outlet box.
and/or have copper conductor. White outlet box wire may be square & ridged and/or have a silver conductor.
Shade
Finial
5. Grounding Connection: Connect fixture ground wire (without insulation) to ground
wire from outlet box (usually with green insulation) with wire connector (not provided).
IMPORTANT: Never connect ground wire to black or white
power supply wires.
6. While making certain all electrical wires are tucked inside of main frame, install the main frame by fastening with a lock washer and coupler onto the top threaded pipe.
7. Install a hex nut onto one end of center pipe leaving about 3/8" (10mm) thread exposed. Screw same end of pipe into coupler. Tighten hex nut.
8. Install bulb (not included). See relamping label located at socket area for type and maximum allowed wattage.
9. Install shade by slipping through the installed center pipe and
then fastening with finial. IMPORTANT: Do not over tighten.
Loading...