Feiss FM306 User Manual

Assembly Instructions For

Ceiling Junction Box

Mounting Plate

Long Machine Screws

3

Supply Wire

Fixture Wires

5

Socket
Assembly

Center Pipe

Cap Nuts

FM306

Junction Box Machine
Screw (not supplied)

4

Pan

6

Bulb
(not included)

1

2

Bracket

(E) 12/4/08

IMPORTANT

TURN OFF THE POWER AT THE MAIN FUSE OR

CIRCUIT BREAKER BOX

BEFORE STARTING INSTALLATION

Carefully unpack and identify all parts before assembly. Bulb

not included.

1. Install center pipe into bottom of socket assembly. Note
correct position of pipe from left diagram.

2. Install brackets onto shade by fastening with rubber washer
and thumb screws from behind.

3. A. Fasten two long machine screws (supplied) into opposite
side of the mounting plate from green grounding screw head.
Leave about 1" (25 mm) of thread exposed from mounting
plate before locking with small hex nuts onto the two
machine screws. Make certain not to spin screws during
fastening of hex nuts.

B. Pass supply wires from the ceiling junction box through

center hole in mounting plate.

C. Attach mounting plate securely to ceiling junction box

with two machine screws (supplied with junction box)
through corresponding slots in mounting plate.

D. At this point, test install pan onto mounting plate by

fastening with two cap nuts. If the two machine screws do
not protrude enough for cap nuts to grab onto or are too
long that does not allow pan to sit flush against ceiling then
must remove pan and adjust the length of screws accordingly.

4. A. Spread the electrical wires so that the black wires are on
one side of the outlet box and the white wires are on the
other side.

B. Electrical connections:
Connect the white wire from the fixture to the white wire of

the outlet box. Connect the black wire from the fixture to
the black wire of the outlet box.

NOTE: Black outlet box wire may be red, round & smooth

and/or have copper conductor. White outlet box wire may be
square & ridged and/or have a silver conductor.

C. Grounding Connection:
Connect fixture ground wire (without insulation) to ground

wire from outlet box (usually with green insulation) with
wire connector (not provided).

IMPORTANT: Never connect ground wire to black or white

power supply wires.

5. Place pan through two machine screws so that it sits flush
against ceiling. Be sure all wires are inside pan. Secure pan to
ceiling by fastening with cap nuts.

7

Square Cap

Finial

Shade

6. Install bulb (not included). See relamping label located at
socket area for type and maximum allowed wattage.

7. Install shade onto pan by fastening with square cap and finial.
NOTE: Before tightening finial, make certain studs located at
top end of brackets are checked into corresponding holes in
pan.