Assembly Instructions For
Mounting Bar
Outlet Box
Mounting Screw
(not supplied)
Threaded Pipe
Bulb
(not included)
Supply Ground Wire
Supply Wire
Fixture Ground Wire
Socket
Lock Washer
Coupler
FM291
Carefully unpack and identify all parts before assembly. Bulb
Fixture Wire
Pan
1. Attach mounting bar securely to ceiling junction box with
Note: mounting bar should be installed with "GND" imprint
2. Fasten one hex nut about 3/4" (19 mm) down from one end
3. Spread the electrical wires so that the black wires are on one
(E) 12/09
IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
not included.
two machine screws (supplied with junction box) through
slot at each end of mounting bar.
and/or two dimples facing down.
of threaded pipe. Then screw same end of threaded pipe into
center hole in mounting bar. At this point test install the pan
onto ceiling through this threaded pipe and make certain 3/8"
(10 mm) of pipe protrude below. If not, then adjust the
threaded pipe location by screwing up or down accordingly.
Once correct threaded pipe location has been adjusted,
remove pan and tighten hex nut against mounting bar. Make
certain not to spin threaded pipe during tightening.
side of the outlet box and the white wires are on the other
side.
Shade
Metal
Ring
Glass Plate
Long Threaded Pipe
4. Electrical connections:
Connect the white wire from the fixture to the white wire of
the outlet box. Connect the black wire from the fixture to
the black wire of the outlet box.
NOTE: Black outlet box wire may be red, round & smooth
and/or have copper conductor. White outlet box wire may be
square & ridged and/or have a silver conductor.
5. Grounding Connection:
Connect fixture ground wire (without insulation) to ground
wire from outlet box (usually with green insulation) with
wire connector (not provided).
IMPORTANT: Never connect ground wire to black or white
power supply wires.
6. Place pan thru top threaded pipe so that it sits flush against
ceiling. Be sure all wires are inside pan. Secure pan to ceiling
by fastening lock washer and coupler onto top threaded pipe.
Note: Coupler must turn at least 3 times, if it does not you
must remove coupler and lengthen threaded pipe accordingly.
7. Install bulb (not included). See relamping label located at
socket area for type and maximum allowed wattage.
8. Install the center pipe by screwing onto bottom of main
frame. Note correct position of center pipe at illustration.
9. A. Place metal ring onto glass plate. Then place shade.
B. While holding firmly onto glass plate, slip the assembled
parts through the long threaded pipe. And then slip cap and
lock them in position by fastening with a hex nut.
C. Install finial by screwing onto protruding threaded pipe.
Cap
Finial
Hex Nut
Loading...