ASSEMBLY INSTRUCTIONS FOR FLUSH MOUNT (CENTER COUPLER) 2011-B (E)
rev. 11/03
Outlet Box
Mounting Strap
Hex Nut
Outlet Box
Mounting Screw
(Not Supplied)
Top
Threaded Pipe
Crown
Socket
Bulbs
(Not Included)
Lock Washer
(External Tooth)
Coupler
Bottom
Threaded Pipe
Shade
HEX NUT
CAP
FINIAL
CAP + FINIAL:
1. If you are placing an existing fixture, disconnect and
Ceiling
Supply
Ground wire
Supply
Wires
Wire Nuts
Fixture Wire
Fixture
Ground Wire
Connect fixture ground wire to ground wire from outlet
remove the old fixture. Expose the supply wiring from
the outlet box.
2. Screw top threaded pipe 3 complete turns into the flat
side of mounting strap and lock in place with hex nut.
3. Fasten the mounting strap to the outlet box using the
two screws supplied with the outlet box.
4. Spread the electrical wires so that the black wires are on
one side of the outlet box and the white wires are on the
other side.
5. Electrical connections:
Connect the white wire(s) from the fixture to the white
wire of the outlet box. Connect the black wire(s) from
the fixture to the black wire of the outlet box.
NOTE: Black outlet box wire may be red, round &
smooth and/or have copper conductor. White outlet box
wire may be square & ridged and/or have a silver
conductor.
Note: Never connect ground wire to black or white
power supply wires.
6. Grounding Connection:
box with wire connector (not provided).
7. Place crown thru top threaded pipe so that it sits flush
against ceiling. Be sure all wires are inside pan. Secure
crown to ceiling by fastening lock washer and coupler
onto top threaded pipe.
Note: Coupler must turn at least 3 times, if it does not
you must remove coupler and lengthen threaded pipe
accordingly.
8. Install bottom threaded pipe into coupler.
9. Install bulbs (not included). See relamping label located
at socket area for type and maximum allowed wattage.
HEX NUT
FINIAL
FINIAL WITH RECESS
AT TOP:
FINIAL
FINIAL WITH FLAT
TOP:
© MURRAY FEISS IMPORT CORP.
10.Flush Mounts With Cap + Finial:
Place shade thru center pipe so that top rim of glass
checks properly into bottom of crown. Secure glass
shade with hex nut, if provided. Do not over tighten.
Then slide cap up and secure with finial.
Flush Mounts With Only Finial-Recessed At Top:
Place shade thru center pipe so that top rim of glass
checks properly into bottom of crown. Secure glass
shade with hex nut. Do not over tighten. Then secure
with finial.
Flush Mounts With Only Finial-Flat Top:
Place shade thru center pipe so that top rim of glass
checks properly into bottom of crown. Secure glass
shade with finial.
M U R R A Y F E I S S
Loading...