Assembly Instructions For
Ø16
Ø4
Ø8
×2 ×2 ×5 ×1 ×1 ×1 ×1 ×1
EXTRA
×3
A
×3
B
B
Ø28
A
×1
C
F2723/3
EXTRA
3
54
3
1
2
7
6C
7
6B
6A
7
C
B
(E) 12/11
Ø4
× 2
× 2 ×5 ×1 ×1 ×1 ×1 ×1
TURN OFF THE POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BOX BEFORE STARTING
Carefully unpack and identify all parts before
assembly. Bulbs not included.
1. Install the fixture loop onto the top of the fixture.
2. Install the top column onto the top of the fixture.
3. This fixture can be mounted onto ceiling either as
chain hung or flush mount:
CHAIN HUNG INSTALLATION:
A. Take fixture wire (with plastic insulation) and
ground wire and thread through fixture loop. Then
install loop onto threaded pipe located at top of
fixture.
B. This fixture is supplied with 2 threaded chain
links. These links are opened and closed by twisting
cylinder on chain link. One threaded chain link
should be installed onto canopy loop and the other
should be installed onto fixture loop. The standard
chain should be installed in between these 2
threaded chain links.
C. Determine the desired length of chain to hang.
Remove any unwanted links with chain plier.
D. Take ground wire and weave through above chain
links, then thread through center hole in canopy
loop. Repeat with fixture wire (wire with plastic
insulation).
FLUSH MOUNT INSTALLATION:
A. Remove and discard canopy loop and threaded
pipe from fixture plate.
B. Thread ground wire and fixture wire through
fixture plate, lock washer, and hex nut. Lock all
together on top of fixture by tightening hex nut onto
threaded pipe.
4. Cut excess wires leaving only 6" (15cm) length of
wires above canopy. Split fixture wire into two
strands. Then strip off 3/4" (19mm) of outer plastic
insulation.
5. Follow enclosed supplement installation instructions
for electrical and fixture installation onto house
outlet box. If you do not have an outlet box at
desired location to attach the fixture then hire a
qualified electrician to create one.
6. A. Slip candle follower on top of candle tubes.
B. Install light bulb (not included). See relamping
label at socket area for type and maximum allowed
wattage.
C. Install the shade onto the bulb.
7. Hang all crystal glass parts as shown on drawing.
NOTE: To replace broken crystal or pin, extras are
included in hardware bag. Replace by gently bending
open pin, remove broken crystal or pin, hook new
one, then close back pin. Avoid bending pin into
sharp angle.
IMPORTANT
INSTALLATION
Ø16
Ø8
Ø28
Loading...