Page 1
Assembly Instructions For
F2661/8+4
Carefully unpack and identify all parts before assembly.
1. Slip fixture loop down through the fixture wires, and
2. Follow enclosed supplement installation instructions
3. A. Install stem onto bottom of fixture.
B. Install candle tube by slipping through sockets.
C. Install candle tube cap onto the top of the candle
D. Install type-B, candelabra base, of 60 Watt maximum
4. Install the large ring onto the bottom of the fixture
5. Install the small ring onto the center of the fixture with
(E) 12/10
IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE
OR CIRCUIT BREAKER BOX BEFORE
STARTING INSTALLATION
Bulbs not included.
then screw on top of fixture.
for electrical and fixture installation onto house outlet
box. If you do not have an outlet box at desired
location to attach the fixture then hire a qualified
electrician to create one.
tube.
bulbs (not included).
with ball cap screws.
cap nut screws.
6. Hang all crystal glass parts as shown on drawing.
NOTE: To replace broken crystal or pin, extras are
included in hardware bag. Replace by gently bending
open pin, remove broken crystal or pin, hook new one,
then close back pin. Avoid bending pin into sharp
angle.
1
3D
3C
2
A
B C B
3B
8 Sets
5
3A
A B C B C
8 Sets
4
Loading...