Assembly Instructions For
1C
1B
6
FIG. 1
CHAIN SUSPENDED
INSTALLATION
F2543/3
32
1C
4
1A
5
8
7A
7B
9
2
3
TURN OFF THE POWER AT THE MAIN FUSE OR CIRCUIT
Carefully unpack and identify all parts before assembly. Bulbs not
included.
1. This fixture can be mounted onto ceiling either as chain hung or
flush mount:
CHAIN HUNG INSTALLATION- Fig. 1:
A. Pass fixture wires through upper column. Then install upper
column by screwing on top of fixture.
B. At this point, determine the desired length of chain to hang.
Remove any unwanted links with chain pliers.
C. This fixture is supplied with two adjustable chain links. These
links are opened and closed by twisting cylinder. One adjustable
chain link should be installed onto loop on top of column and the
other should be installed onto canopy loop. The standard chain
should be installed in between these two adjustable chain links.
D. Take ground wire (without plastic insulation) and weave through
above chain links, then thread through center hole in canopy loop.
Repeat with fixture wires (with plastic insulation).
FLUSH INSTALLATION- Fig. 2:
A. Remove and discard upper column.
B. Remove and discard canopy loop.
C. Thread fixture wires through threaded pipe, then screw threaded
pipe into top of fixture.
D. Thread fixture wires through canopy, flat washer, lock washer, and
hex nut. Lock all together on top of fixture by tightening hex nut
onto protruding threaded pipe.
2. Cut excess wires leaving only 6" (15 cm) length of wires above
canopy. Split fixture wire into two strands. Then strip off 3/4"(19
mm) of outer plastic insulation.
3. Follow enclosed supplement installation instructions for electrical
and fixture installation onto house outlet box. If you do not have an
outlet box at desired location to attach the fixture then hire a
qualified electrician to create one.
4. Hook decorative chains first onto the column and then proceed to
hook onto arms.
5. Install threaded pipe onto bottom of harp. At this point test install
larger center shade and cover to make certain about 1/4” (5mm) of
thread protrude out. If not then adjust the threaded pipe length
accordingly. Secure by tightening hex nut.
(E) 11/09
IMPORTANT
BREAKER BOX
BEFORE STARTING INSTALLATION
1B
1A
FIG. 2
FLUSH INSTALLATION
6. Install type-C7 of 10 Watt maximum candelabra base bulb (not
included).
NOTE: Do not install bulb exceeding 10 Watt.
7. A. Install center shade and cover onto bottom of fixture by securing
with finial.
B. Install hanging drop by hooking onto finial.
8. Install side shade onto fitters by fastening with spacer tube and
counter ring. Use supplied wrench to tighten counter ring.
9. Install type-B, candelabra base, of 60 Watt maximum bulbs (not
included) onto sockets.
Loading...