Feiss F2475 User Manual
Assembly Instructions For
Require
d
Extra
Small
Notched Cover
4
5
6
1
2
1
Fixture Loop
3
X6X18X7 X6
X6
14
54 6
13 bead14 bead 11 bead
X6
Bulb
(not included)
2
F2475/6
7
8 9
12 bead 16 bead
X6
X6
Candle Follower
(Included with
MBZ nish only)
Candle
Tube
2
Bobeche
1
Socket
X1
1
1 X3
(E) 8/13
10
TURN OFF THE POWER AT THE MAIN FUSE OR CIRCUIT BREAKER
Carefully unpack and identify all parts before assembly. Bulbs
not included.
1. Turn arms so they are equally spaced apart from each other.
Extra PIN
Qty.
12
12
24
BEFORE STARTING INSTALLATION
PIN PART
IMPORTANT
BOX
PIN
DESCRIPTION
Small
S Hook
Large
S Hook
Small Bead
Hook
1
Ring
2. A. Slip small notched cover and xture loop through xture
wires.
B. Install the small notched cover on top of xture, making
Arm
2
3
FACTORY
10
INSTALLED
7
8
Threaded Pipe
certain arms are locked onto It’s notches, by fastening with
xture loop.
3. Install ring onto xture by fastening with thumb screws from
behind of arms.
4. Follow enclosed supplement installation instructions for
electrical and xture installation onto house outlet box. If you do
not have an outlet box at desired location to attach the xture
than hire a qualied electrician to create one.
IMPORTANT: WHEN FOLLOWING SUPPLEMENT INSTRUCTIONS
STEP #6, MAKE CERTAIN TO SLIDE CRYSTAL BOBECHE (IN
BETWEEN COLLAR RING AND CANOPY) DOWN THE CHAIN. See
above illustration.
5. A. Install a hex nut onto one end of threaded pipe leaving about
3/8” (10mm) of thread exposed. Then install same end of pipe
by screwing onto bottom of xture. Tighten hex nut.
B. Slip large notched cover through the installed threaded pipe
and secure by fastening with nial. Make certain arms are
locked onto it’s notches before tightening nial.
Large Notched Cover
6. A. Install crystal bobeche by slipping through sockets.
Finial
9
B. Install candle tube by slipping through sockets.
C. Install candle follower onto top of candle follower (for MBZ
nish only).
D. Install type-B, candelabra base, of 60 Watt maximum bulbs
(not included).
7. Hang all crystal glass parts as shown on drawing.
NOTE: To replace broken crystal or pin, extras are included in
hardware bag. Replace by gently bending open pin, remove
broken crystal or pin, hook new one, then close back pin. Avoid
bending pin into sharp angle.
Loading...