Feiss F2324-3 User Manual

Assembly Instructions For

Canopy (Fixture Plate)

Ball Cap Nut

Canopy Loop

Adjustable
Link

Chain

Fixture Loop

Fixture
Wires

F2324/3

Bulb
(not included)

Candle
Tube

Socket

Fig. 1

CHAIN HUNG

INSTALLATION

(E) 10/07

IMPORTANT

TURN OFF THE POWER AT THE MAIN FUSE OR

CIRCUIT BREAKER BOX

BEFORE STARTING INSTALLATION

Carefully unpack and identify all parts before assembly. Bulb

not included.

1. This fixture can be mounted onto ceiling either as chain hung
or flush mount:

CHAIN HUNG INSTALLATION- Fig. 1:
A. If Fixture loop is separated from top assembly:

Thread fixture wire and ground wire through fixture loop.
Then install fixture loop by screwing into top threaded pipe.

B. At this point, determine the desired length of chain to

hang. Remove any unwanted links with chain pliers

C. This feature is supplied with 2 threaded chain links. These

links are opened and closed by twisting cylinder on chain link.
One threaded chain link should be installed onto fixture loop
and the other should be installed onto canopy loop. The
standard chain should be installed in between these 2
threaded chain links.

D. Take ground wire and weave thru above chain links, then

thread thru center hole in canopy loop. Repeat with fixture
wire (wire with plastic insulation).

FLUSH INSTALLATION- Fig. 2:
A. Remove and discard fixture loop.
B. Remove and discard canopy loop and threaded pipe from

canopy.

C. Thread fixture ground wire and fixture wire thru

canopy,flat washer, lock washer, and hex nut. Lock all together
on top of fixture by tightening hex nut onto top threaded
pipe.

2. Cut excess wires leaving only 6" (15 cm) length of wires
above canopy. Split fixture wire into two strands. Then strip
off 3/4"(19mm) of outer plastic insulation.

Hex Nut,
Lock Washer

Canopy
Threaded
Pipe

Canopy
Loop

Canopy
(Fixture Plate)

Ball Cap Nut

Fixture
Wires

Fig. 2

FLUSH MOUNT

INSTALLATION

3. Follow enclosed supplement installation instructions for
electrical and fixture installation onto house outlet box. If
you do not have an outlet box at desired location to attach
the fixture than hire a qualified electrician to create one.

4. Slip candle tube over sockets.

5. Install bulbs (not included). See relamping label located at

socket area for type and maximum allowed wattage.