Feiss F2303 User Manual
Assembly Instructions For
1
8 pcs. 40 pcs. 1 pc. 1 pc.
Center Body
2
3
Fixture Wires
Fixture Loop
1
4
F2303/8
Cap Screw
Arm
Bulb
(not included)
(E) 9/07
IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly.
Bulb not included.
1. Spread open arms so they are evenly spread to each
other. Then lock upper section of arms with cap screw
onto corresponding holes at center body.
2. Screw bottom threaded pipe into coupler. Slide
notched cap over bottom threaded pipe and lock arms
into its notches. Lock notched cap into position by
fastening finial onto bottom threaded pipe.
3. Carefully thread fixture wire and ground wire through
fixture loop. Screw fixture loop onto center body until
secure.
4. Spread open lower tier arms so they are evenly spaced
to each other. Then install the arms onto middle tier
arms by fastening with ball cap nuts.
Coupler
Finial
Bottom Tier Arm
2
3
4
2
2
Notched
Cap
2
Large Finial
Candle
Tube
Ball Cap Nut
Socket
2
5. Follow enclosed “Chain Suspended Fixture Installation
Instructions” for electrical and fixture installation onto
ceiling outlet box.
6. Install large finial onto bottom section of lower tier
arm.
7. Place candle tubes over candelabra sockets and screw
bulbs (not included) into sockets to secure. See
relamping label on candle tube or type and maximum
allowed wattage.
8. Hang all crystal glass parts as shown on drawing.
NOTE: To replace broken crystals extras are included
in hardware bag. Replace by gently bending open pins,
remove broken crystal, hook new one, then close back
pins. Avoid bending pins into sharp angle.
Loading...