
Assembly Instructions For
F2262/4, F2263/6, F2264/9
4
2
Fixture Loop
Notched Cover
6
5
Socket
Bulb
(not included)
Candle
Tube
Frame Arm
1
IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly.
Bulb not included.
1. Spread open arms so they are evenly spaced to each
other.
2. Thread fixture wires through upper notched cap and
fixture loop. Then slide down the notched cap until the
arms are locked into it's notches. Screw fixture loop
onto protruding threaded pipe until secure.
3. A. Insert ring onto frame from below. NOTE: The
wavy crest of ring must be located at top as shown on
left diagram.
B. While one person is firmly holding onto frame,
making certain frame arms are equally spaced apart
from each other, have another person gently lift the
ring until it aligns onto the six frame arms. NOTE: Be
careful not to scratch paint finish.
C. Lock ring onto frame arms by fastening with ball
cap screws.
(E) 10/07
4. Follow enclosed supplement installation instructions
for electrical and fixture installation onto house outlet
Ring
3
Cap
Screw
Coupler
7
Threaded Stud
box. If you do not have an outlet box at desired
location to attach the fixture than hire a qualified
electrician to create one.
5. Install candle tube onto sockets.
6. Install light bulb (not included). See relamping label
located near socket area for type and maximum
allowed wattage.
7. Install threaded stud by screwing into bottom coupler.
Then slip cover and bottom cover through the installed
stud. Secure all together by fastening with finial.
Cover
Bottom Cover
Finial