Feiss F2228 User Manual
ASSEMBLY INSTRUCTIONS FOR F2228/6
(E) 3/11
Fixture Loop
Notched Cover
4
2 3
1
Required Crystals Qty. : 1 1 24 3 3 3 6 6 6
Extra Crystals Qty. : 0 0 3 0 0 0 1 1 1
Extra Hooks Qty. : 13
Center Pipe
Leaf
Round Plate
Cover
Finial
2
Bulb
(not included)
Candle Tube
TURN OFF THE POWER AT THE MAIN FUSE
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before
assembly. Bulbs are not included.
1. Spread open all arms so they are evenly spaced
apart to each other.
2. Lock lower tier arms by fastening with cap
screw onto center body.
5
4
IMPORTANT
OR CIRCUIT BREAKER BOX
7
6 8
9
Lower Leaf
Assembly
6
1
Curl
Assembly
Cap Screw
7
5
8
Bobeche
3
Socket
9
3. Slip leaf and cover (with notches) through
threaded end of center pipe. Then slip same
end of pipe through round plate located at top
section of fixture. Make certain arms are
locked onto the cover notches. Secure all
together from below by slipping another cover
(without notches) and fastening with cap nut.
4. Install curl assembly by screwing into middle
of fixture.
5. Follow enclosed supplement installation
instructions for electrical and fixture
installation onto house outlet box. If you do
not have an outlet box at desired location to
attach the fixture than hire a qualified
electrician to create one.
6. Install lower leaf assembly by screwing onto
bottom of fixture.
7. Install bobeches by slipping through socket
until it securely sits onto fitter.
8. Slip candle tube over sockets.
9. Install bulbs (not included). See relamping
label located near socket area for type and
maximum allowed wattage.
10. Hang all crystal glass parts as shown on
drawing. NOTE: To replace broken crystals
extras are included in hardware bag. Replace
by gently bending open pin, remove broken
crystal, hook new one, then close back pin.
Avoid bending pin into sharp angle.
Loading...