ASSEMBLY INSTRUCTIONS FOR F2008/8+4+4
(E) REV 9/13/06
Font
Short
Threaded
Pipe
Glass Lid
Large
Washer
Hex Nut
Bulb (not
included)
Counter
Ring
Center
Glass Shade
10
TURN OFF THE POWER AT THE MAIN FUSE
4
3
Cover
9
Fixture Loop
Short Screws
Upper Column
Upper Tier Arm
Bulb
(not included)
2
Mid Tier Arm
8
Ball
Cap
Nut
Counter Ring
Side
Glass
Shade
6
1. Carefully remove all parts from box and
remove wrappings. NOTE: DO NOT
YET REMOVE WRAPPINGS
SURROUNDING ARMS. Carefully
lay parts on a non-abrasive surface and
identify all parts before assembly. Bulb
not included.
2. Spread open all arms so they are equally
spaced apart to each other.
3. A. Install arms onto top of upper column by
B. Install the upper column onto top section
7
C. Install cover by slipping and letting it sit
D. Install fixture loop by screwing onto
E. Remove all wrappings from arms.
4. Follow enclosed supplement installation
OR CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
fastening with short screws.
of mid tier arms by fastening with ball cap
nuts.
on top of the center column.
threaded pipe which is protruding above the
cover.
instructions for electrical and fixture
installation onto house outlet box. If
you do not have an outlet box at desired
location to attach the fixture than hire a
qualified electrician to create one.
IMPORTANT
Center Font
Socket
Fitter
Bottom Coupler
5
Short Threaded Pipe
Lower Font
Finial
5. Screw short threaded pipe into bottom
coupler. Then slip lower font through the
pipe and secure by fastening with a finial.
6. Install side glass shade onto fitters by
fastening with counter ring.
7. Install bulbs (not included). See relamping
label located near socket area for type and
maximum allowed wattage.
8. Install center glass shade onto center font by
fastening with counter ring.
9. Install a candelabra base of 25 Watt
maximum bulb (not included) into center
socket.
10. Assemble glass lid and font with large
washer and hex nut.
11. Sit lid gently on top of center glass shade.
©MURRAY FEISS IMPORT LLC.
M U R R A Y F E I S S