Fein Optic Mi50 User Manual
Mi50 Inverted Microscope User’s Manual
Fein
info@feinoptic.com
Mi50 Microscope Components
Beam
Splitter
Dust
Protector
Siedentopf
Trinocular Head
Stage Plate
Mechanical
Stage
Locking
Screw
Hex Wrench
Storage
ECO Energy
Saving
Button
Light
Rheostat
Tension
Adjustment
Coarse
Focus
Fine
Focus
On/O Switch
Base
Color
Filter Slider
Aperture
Diaphragm
Field
Diaphragm
1
Fein
Mi50 Microscope Components
Objective
Lens
Quintuple
Nosepiece
Brighteld /
Darkeld Lever
Fein
PolarizerAnalyzer
2
Mi50 Inverted Microscope Assembly
1. Install the bulb into the lamp housing.
2. Connect the lamp housing to the microscope frame.
3. Connect the nosepiece to the frame.
4. Screw the objective lenses onto the nosepiece.
5. Insert the stage plate.
6. Connect the stage clips.
7. Insert the eyepieces into the eyetubes.
8. Insert the color lter slider into the illuminator port.
9. Connect the power cord.
10. Place the inner hex spanner into its holder on the frame.
NOTE: Each of the above installation steps is outlined in detail on the following pages.
3
Fein
Mi50 Inverted Microscope Operation Instructions
Do not shake or drop the microscope.
Do not expose the microscope
to direct sun, high temperatures,
high humidity, dust, or damp
environments. Use a at work surface.
When moving the microscope use both hands, holding the handle at the back
(1) and the frame at the front (2) as shown in the image at right. Do not carry by
holding stage.
When working make sure there is plenty of room for heat dissipating around the
light source (3).
Set the power switch (4) to o “O” before replacing a bulb or fuse, and wait until the
lamp is cool. The power switch is located on the side of the microscope. Microscope
uses 12v, 100w Halogen bulb. (Part #12v100wH).
Voltage range of 100~240V is supported. Use the power cord supplied with the
microscope.
Operating indoor temperature should be 5°C~40°C (41°F~104°F), with a max
relative humidity of 80%.
Fein
4
Loading...