Page 1
radius with power to all fans.
R
1
F
ego Precision Industrial Co L
td
>>
F7091BLN0
Remote Control Set-up
! Note:
Code match the transmitter with the receiver
Note: receiver itself has NO DIP switch.
Speed Up 1-2-3-4-5-6
Down 6-5-4-3-2-1
To start the fan press speed button
To change speed of fan press or (indicated by a short buzzer sound)
LCD indicates maximal speed (max)
On/Off Press the button to start or switch off the fan
Forward For cooling effect and in combination with Air Condition System (clockwise rotation)
Reverse To support heating system to exchange temperature (counter clockwise rotation)
Light Press the button to turn on or switch off the LED light (Light is optional)
Code match the Transmitter (Hand held) with the Receiver
Æ The transmitter and receiver will memorise the code for future use (also if switched off).
Code matching is required even if the remote control may control the fan out of the box !
Remote Control Code Setting
Set your Dip Switch to control individual
Dip Switch
1. Set the code to be encoded by the Dip Switch of transmitter
2. Switch on the main power to activate the receiver, indicated by (one beep)
3. Within 3 minutes after the power is turned on (one beep)ƉƌĞƐƐƚŚĞƚƌĂŶƐŵŝƚƚĞƌƐKEK&&
key and do not release (min. 5 seconds) until receiver issues (four beep) short sounds which
indicates successful code match
4. After successful code match, the fan automatically returns to the original speed as indicated
on LCD screen
5. Press any transmitter button to check for proper functioning
6. For code changes, repeat steps 1 to 5
fan(s) (one per fan handset) and only
power to one fan receiver per time.
Chose same code setting for up to 10 fans
controlled by one handset within a 7m
10
- [ -
Page 2
Federal Communication Commission Interference Statement
15.21
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
15.19
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
FCC RF Radiation Exposure Statement:
1. This Transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
2. This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment.
Loading...