Page 1
INSTALLATION INSTRUCTIONS
FOR
MODEL GH1K GRILLE LIGHT KIT
2561230C
REV. C 407
Printed in U.S.A.
SAFETY MESSAGE TO INSTALLERS AND USERS
People’s lives depend on your safe installation of our products. It is important to
read, understand and follow all instructions shipped with the products. In addition, listed below are some other important safety instructions and precautions
you should follow:
• To properly install a light assembly:
you must have a good understanding
of automotive electrical procedures
and systems, along with proficiency
in the installation and use of safety
warning equipment.
• DO NOT install equipment or route
wiring in the deployment path of an
air bag.
• When drilling into a vehicle structure, be sure that both sides of the
surface are clear of anything that
could be damaged.
A. KIT CONTENTS LIST.
Qty. Description Part No.
1 Bracket, Switch 8573147
1 Switch, SPDT 122385
2 Screw, Hex Hd., Type B, 1/2" 7011A146-08
3 Terminal, QD, 250, Female 224A216A-01
1 Socket, Flasher 8443A015
B. INSTALLATION.
This product is intended for supplemental warning and for use in conjunction
with an approved primary warning light
system. This strobe head can be powered
by several types of strobe power supplies. Consult local codes and regulations to determine if the power supply/
strobe head combination complies.
NOTE
For maximum coverage and effectiveness, the
light assembly should be mounted in a horizontal orientation.
• A light system is a high current device. In order for it to function properly, a separate ground connection
must be made. It should be connected
to the negative battery terminal.
• Locate light system controls so the
VEHICLE and CONTROLS can be
operated safely under all driving conditions.
• You should frequently inspect the
light to ensure that it is operating
properly and that it is securely attached to the vehicle.
• File these instructions in a safe place
and refer to them when maintaining
and/or reinstalling the product.
Failure to follow all safety precautions and
instructions may result in property damage,
serious injury, or death to you or others.
1. Determine the desired mounting location for
all the components. Before performing any installation, plan all wiring and wire routing.
NOTE
For maximum serviceability, position the
flasher in a accessible location.
If shorted to vehicle frame, high current conductors can cause hazardous
sparks resulting in electrical fires or
molten metal. Before proceeding, disconnect the positive (+) battery terminal
connection(s).
2. Install the light assemblies as described in
the instructions packed with the units.
Page 2
3. Install the switch bracket in a location which
290A2846C
FUSE, 10 AMP
USER SUPPLIED
MOUNTING BRACKET,
SWITCH
TERMINAL,QD
FEMALE(3)
SCREW, HEX HEAD
TYPE B, 1/2" (2)
GROUND
BLACK
GROUND
BLACK
GROUND
SWITCH, SPDT
SOCKET,
FLASHER
FA3
GRILLE LIGHT ASSEMBLY
WITH MOUNTING
BRACKET
GRILLE LIGHT ASSEMBLY
WITH MOUNTING
BRACKET
+12 VOLTS
TYPICAL WIRING DIAGRAM
X
L
L
1
2
3
allows the vehicle, controls, and switch to be operated
safely at all times.
4. Using figure 1 as a guide, complete the electrical connections as shown. Be sure to install a usersupplied 10-ampere in-line fuse as shown.
5. Reconnect the positive (+) battery terminal
connection(s).
6. Test the system for proper operation.
NOTE
NOTE
Refer to the instructions packed with Model
FA3 for the proper electrical connection of the
flasher.
Refer to the instruction sheet packed with
Model GH1 for maintenance instructions and
replacement parts.
Copyright 2007 Federal Signal Corporation
Figure 1.
-2-
Loading...