Installation and Maintainance Instructions
Model BPL26L
Battery-Powered LED Warning Light
Installation and Maintenance Instructions
Safety Messages to Installers and Users
Follow all instructions shipped with this product. This device
is to be installed by a trained electrician who is thoroughly
familiar with the National Electrical Code and will follow the
NEC Guidelines as well as local codes.
The selection of the mounting location for the device, its
controls and the routing of the wiring is to be accomplished
under the direction of the facilities engineer and the safety
engineer. In addition, listed below are some other important
safety instructions and precautions you should follow:
• Read and understand all instructions before installing or
operating this equipment.
• Do not stare directly into the LED at a close range or
permanent damage to your eyesight may occur.
• Test the warning LED to ensure that it is operating properly.
• After testing is complete, provide a copy of this instruction
booklet to all operating personnel.
• Establish a procedure to routinely check the light system for
proper activation and operation
Failure to follow all safety precautions and instructions may
result in property damage, serious injury, or death.
Unpacking the Model BPL26L
After unpacking the product, examine it for damage that
may have occurred in transit. If the warning device has been
damaged, do not attempt to install or operate it. File a claim
immediately with the carrier, stating the extent of the damage.
Carefully check all envelopes, shipping labels, and tags before
removing or discarding them.
Battery Powered Warning LED
Installation and Maintenance Instructions
Mounting the BPL26L
The Model BPL26L is designed for portable use. It comes with
a magnetic mounting base.
NOTE: The holding power of the magnetic mount is dependent
upon surface nish, surface atness, and thickness of the steel
mounting surface. Therefore, to establish a good magnetic
coupling:
• Ensure that mounting surface is at.
• Keep the mounting surface and magnet clean, dry, and free
of foreign particles that prevent good surface contact.
Operating the BPL26L
LIGHT HAZARD: To be an effective warning device, an
emergency warning system produces bright light that can be
hazardous to your eyesight when viewed at close range. Do not
stare directly into the LED at a close range or permanent damage
to your eyesight may occur.
Press the black rubber switch cover on the side of the battery
housing until you hear a click. The light will begin to ash.
Repeating the above procedure shuts the light off.
Battery Powered Warning LED
Installation and Maintenance Instructions
Replacing the Batteries
The Model BPL26L is powered by two 6 V spring-terminal
lantern batteries.
To replace the batteries:
1. Open the battery housing by removing the 1/2-inch bolt and
neoprene washer.
2. Bend the upper housing out slightly on each side and pull
the lower housing out.
3. Install the batteries as shown in Figure 1 by standing the
batteries in the bottom housing with the spring terminals
aligned with the + and – symbols on the bottom of the
battery housing.
4. Push the upper housing back onto the lower housing and
replace the neoprene washer and 1/2-inch bolt.
Figure 1 Location of battery compartment in bottom housing
6.88 in
(174.75 mm)
3.59 in
(91.2mm)
BOTTOM OF
BATTERY CASE
Battery Powered Warning LED
BATTERIES
Installation and Maintenance Instructions
Model BPL26L Battery-Powered LED
Table 1 Replacement parts
Description Part Number
Dome, Amber K8263079
Dome, Blue K8263079-01
Dome, Red K8263079-02
Dome, Green K8263079-03
Dome, Clear K8263079-04
Loading...