How it Works
FDS
Loading...
FD151CMT

FDS FD151CMT Installation And Operation Manual

Download
Document Number:
MAN – FD151CMT
Rev:
E
© 2017 FDS Avionics Corp. All Rights Reserved.
TECHNICAL SUPPORT
470-239-7421 or FDSAvionics.com
Installation and Operation Manual
FD151CMT
15.1” LCD and Ceiling Mount
15.1” LCD and Ceiling Mount
Document Number:
MAN – FD151CMT
Rev:
E
© 2017 FDS Avionics Corp. All Rights Reserved.
TECHNICAL SUPPORT
470-239-7421 or FDSAvionics.com
Table of Contents
General Information................................................................................................................ 3
Front View ............................................................................................................................... 3
Additional Information ........................................................................................................ 3
Specifications ......................................................................................................................... 4
Installation Instructions ....................................................................................................... 4
Power ........................................................................................................................................ 5
Wiring Suggestions ............................................................................................................... 5
S- Video/Composite and Audio Wiring ............................................................................ 5
VGA .......................................................................................................................................... 6
Power and Ground Wiring .................................................................................................. 7
Power and Video .................................................................................................................... 8
Technical Drawing ...........................................................................................................9-10
Operation Instructions ........................................................................................................ 11
Technical Support ................................................................................................................ 12
Instructions for Continued Airworthiness ..................................................................... 12
Warranty ................................................................................................................................ 13
Revisions Log ...................................................................................................................... 14
Document Number:
MAN – FD151CMT
Rev:
E
© 2017 FDS Avionics Corp. All Rights Reserved.
TECHNICAL SUPPORT
470-239-7421 or FDSAvionics.com
General Information
The FD151CMT is a 15.1" LCD and Ceiling Mount. The high resolution LCD is perfect for cabin video and graphical entertainment, and has features that allow installation in the smallest of mounting areas with the minimum of interface equipment.
Front View
Additional Information
The FD151CMT is very rugged with the mounting structure and the internal pivot parts manufactured from milled aluminium. The ceiling mounting frame is mounted in the aircraft where it will provide optimum viewing enjoyment by the passengers, resulting in a smooth shape that houses the LCD and blends into the cabin headliner.
Deployment is via a mechanical latch at the font of the unit. Sliding the latch releases the. To stow the display the operator would push the display up to the ceiling position where a positive latch occurs.
Document Number:
MAN – FD151CMT
Rev:
E
© 2017 FDS Avionics Corp. All Rights Reserved.
TECHNICAL SUPPORT
470-239-7421 or FDSAvionics.com
Specifications
Supported Resolution
XGA 1024x768
Display Brightness
400 cd/m
2
Display Dimensions
14.14”(W) x 11.95”(H) x 1.1”(D)
Mount Dimensions – STOWED Mount Dimensions – DEPLOYED
15.87”(W) x 15.87”(H) x 1.88” (D
15.87”(W) x 15.87”(H) x 13.90” (D)
LCD Dimension
11.89”(W) x 8.89”(H)
Weight
14.74 lbs.
Power
28VDC @ 1.5 Amps
PC Video Input
VGA (High Density DB-15 Connector)
Video Input
2 Composite
Video Type Supported
NTSC/PAL
Screen Control
On-Screen Display Menu
Remote Control
IR, included
Case Materials
Aluminum
Mount Type
Piston Hinge Ceiling
Installation Instructions
All cabin entertainment equipment, such as the FD151CMT, should be installed on a non-essential bus and have a dedicated circuit breaker. It is a requirement that a switch be installed in the cockpit so that the pilot can de-energize the entertainment system should it become necessary.
The order in which you proceed is up to the installation center. We suggest that you first look at the mounting plate prior to installing the LCD to make sure you have the proper room and conditions in the aircraft to mount the display to the ceiling. Most aircraft have a significant curvature in the headliner and it will probably be necessary to modify the headliner to mount to a structure that will hold this mount.
Once it has been determined that you have sufficient room and mounting locations for the FD151CMT, then it would be appropriate to start mounting the base to the frame. The FD151CMT is attached to the aircraft with eight #10 screws. There are eight attach points on the top plate.
There is one DB-15 male connector on a 12” cable coming from the LCD, used for power, VGA, and two composite inputs.
Document Number:
MAN – FD151CMT
Rev:
E
© 2017 FDS Avionics Corp. All Rights Reserved.
TECHNICAL SUPPORT
470-239-7421 or FDSAvionics.com
Power
This is a 28VDC monitor that requires 1.5 Amps to operate. requirements to install the product in compliance with industry standards and safety.
Wiring Suggestions
All shields should be grounded to the connector at the source, and floating at the display.
Avoid routing video wiring parallel to:
AC wiring Strobe wiring DC motor supply cables Inverter cabling Or any other potential noise source
S-Video/Composite and Audio Wiring
Recommended cable for s-video/composite and audio purposes is PIC 75 Ohm Coax, P/N V76261. This is a lightweight, flexible, and low signal loss cable which meets FAA flammability requirements of FAR 23.1359(d), FAR 25.853(a) and FAR 25.869(a)(4).
Similar aviation coaxial cable can be used from other vendors, as well. Some aircraft are prone to AC noise - we recommend adding to the composite source a
75 Ohm video isolation transformer such as Deerfield Laboratory, Inc. Part No. 162-1 (www.deerfieldlab.com, (650) 632-4090). In most cases this should be added to the video output of the source.
Document Number:
MAN – FD151CMT
Rev:
E
© 2017 FDS Avionics Corp. All Rights Reserved.
TECHNICAL SUPPORT
470-239-7421 or FDSAvionics.com
VGA Wiring
Recommended cable for VGA purpose is ECS P/N 453005. This is a single shielded cable containing 5 separate coaxial cables, color-coded to match the functions of the wires.
We recommend coax cables be terminated using solder sleeve coaxial cable terminators such as Raychem Part Number CWT-4174-W122-5/9.
Document Number:
MAN – FD151CMT
Rev:
E
© 2017 FDS Avionics Corp. All Rights Reserved.
TECHNICAL SUPPORT
470-239-7421 or FDSAvionics.com
Power and Ground Wiring
This is a 28VDC monitor that requires 1.5 amps of power to operate. To operate properly this monitor requires an input voltage of 18-29VDC.
The rated current of the equipment and associated voltage drop should be taken into consideration when selecting wire gauge. The following example is based on an install with a 28VDC power system and a total of 50 feet of wire between the circuit breaker, monitor and ground.
Example: 22awg wire has 16.2 Ohms per 1000 feet, this equates to .81 Ohms for 50 feet. 1.5 Amps of current on .81 Ohms will drop 1.22 Volts.
Resistance of Wire Type M22759/16-**
(** = Gauge)
Gauge (AWG)
OHMS/1000’
24
26.20
22
16.20
20
9.88
16
4.81
12
2.02
10
1.26
8
.701
Also, use short heavy gauge wire and a clean tight connection for ground.
It is the installer's responsibility to understand the product's requirements to install the product in compliance with industry standards and safety.
Document Number:
MAN – FD151CMT
Rev:
E
© 2017 FDS Avionics Corp. All Rights Reserved.
TECHNICAL SUPPORT
470-239-7421 or FDSAvionics.com
Power/Video
Pin out for High Density DB-15 Receptacle
Connector
P/N: M24308/2-286 or Equivalent
Crimp Contacts
P/N: M39029/57-354 or Equivalent
Pin
Number
Description
1
28VDC Power
2
28VDC Ground
3
Composite Video 1 - Signal
4
Composite Video 1 - Shield
5
Composite Video 2 - Signal
6
Composite Video 2 - Shield
7
N/C
8
N/C
9
Red Video (Pin 1 on Standard VGA)
10
Green Video (Pin 2 on Standard VGA)
11
Blue Video (Pin 3 on Standard VGA)
12
Red Ground (Pin 6 on Standard VGA)
13
Green Ground (Pin 7 on Standard VGA)
14
Horizontal Sync (Pin 13 on Standard VGA)
15
Vertical Sync (Pin 14 on Standard VGA)
Document Number:
MAN – FD151CMT
Rev:
E
© 2017 FDS Avionics Corp. All Rights Reserved.
TECHNICAL SUPPORT
470-239-7421 or FDSAvionics.com
Technical Drawing
Document Number:
MAN – FD151CMT
Rev:
E
© 2017 FDS Avionics Corp. All Rights Reserved.
TECHNICAL SUPPORT
470-239-7421 or FDSAvionics.com
Document Number:
MAN – FD151CMT
Rev:
E
© 2017 FDS Avionics Corp. All Rights Reserved.
TECHNICAL SUPPORT
470-239-7421 or FDSAvionics.com
Operation Instructions
The FD151CMT automatically turns on when deployed and off when stowed. No pilot or aircrew action is necessary during flight or ground operation. Passengers can change the video output from the FD151CMT remotely throughout the cabin with the included IR remote.
Power
Document Number:
MAN – FD151CMT
Rev:
E
© 2017 FDS Avionics Corp. All Rights Reserved.
TECHNICAL SUPPORT
470-239-7421 or FDSAvionics.com
Technical Support
Should you have any questions concerning this product or other FDS Avionics Corp. products, please contact our Product Support representatives at (470) 239-7421.
FDS Avionics Corp.
6435 Shiloh Road Alpharetta, GA 30005 Phone: +1 (470) 239-7400 Fax: +1 (470) 239-7439 Email: sales@FDSAvionics.com
For further product information, technical data and sample wiring diagrams, please click on the Dealers section of our web site at www.FDSAvionics.com
Instructions for Continued Airworthiness
The FD151CMT is designed not to require regular general maintenance.
Document Number:
MAN – FD151CMT
Rev:
E
Revision Date:
05/15/2017
Page 13 of 14
© 2015 FDS Avionics Corp.. All Rights Reserved.
TECHNICAL SUPPORT
470-239-7421 or FlightDisplay.com
Warranty Information
All FDS Avionics Corp. (FDS) products are warranted to be free from material or manufacturing defects for a period of 24 months from the date of shipment for General Aviation customers or 12 months from the date of shipment for Government/Special Mission customers. Any material or repair workmanship for in warranty repair service will be specifically warranted for 90 days or the remainder of the original warranty period, whichever is longer. If the original warranty period has expired, the 90 day repair warranty is limited to the material and workmanship specific to the repair activity completed.
The following conditions are exclusions to warranty coverage:
1. Labor costs associated with installation, removal or reinstallation of any product.
2. Damage to or malfunction caused by any unauthorized alteration made to the product.
3. Resolving signal quality issues caused by externally generated noise introduced by aircraft electrical systems or other components connected to any FDS product.
4. Any malfunction caused by improper installation or connection to aircraft wiring, industry standard cabin management/ inflight entertainment systems, or third party commercial equipment not specifically identified as compatible with FDS products.
5. Any malfunction caused by installation that does not conform to precautions associated with operating environments listed in the operating manual or consistent with industry best practices such as; high temperature, adequate ventilation, high humidity, high dust, or power surges.
6. Cosmetic damage or damage to internal components caused by installation or removal, failure to follow installation or operating instructions, or any neglect or misuse of the product.
7. Any product that is returned for service with a broken tamper evident seal, indicating tampering or improper handling of the product by an unauthorized person. Violation of product tamper evident seals or modification of factory installed serial and PMA labels voids any warranty, either expressed or implied.
The FDS technical support team is available to provide distance troubleshooting support during business hours (8:00am to 5:00pm EST) Monday through Friday at (470) 239-7421.
Many repair requests can be resolved through distance support and may not require return of merchandise to the factory. If a product must be returned to the factory for repair, an RMA number will be issued as directed by the technical support team and communicated by the repair coordinator.
Upon request by the customer, FDS may send a service technician onsite to repair any non-PMA products. The
travel expenses incurred to include transportation, lodging and meals along with the technician’s hourly rate shall be
payable by the customer in accordance with FDS’ applicable rates and procedures.
FDS Avionics Corp. will, upon receipt of returned merchandise, remanufacture or replace the unit at our discretion and return the product by Ground Return Shipping. Express return shipment will be the responsibility of the sender.
This warranty is not transferable. Any implied warranties expire at the express limited warranty expiration date. FDS shall not be held liable for any
indirect, special, punitive, incidental or consequential damages. Some states do not allow limitation on the length of an implied warranty. In such states, the exclusions or limitations
of this limited warranty may not apply.
Document Number:
MAN – FD151CMT
Rev:
E
Revision Date:
05/15/2017
Page 14 of 14
© 2015 FDS Avionics Corp.. All Rights Reserved.
TECHNICAL SUPPORT
470-239-7421 or FlightDisplay.com
Log of Revisions
Rev
Date
Page
Description
A
01/25/2007
---
---
B
04/10/2009
2,9
Updated specifications, warranty info
C
05/18/2009
4,5,6,10
Updated S-Video/Composite info, Power & Ground Wiring, Pinout info, Assembly Drawing replaced
D
08/24/2012
Updated format, warranty and non-PMA info
E
05/15/2017
ALL
New corporate name, Warranty, S-video, New Format
Loading...
Buy Points How it Works FAQ Contact Us Questions and Suggestions Privacy Policy Cookie Policy Terms of Use