FAVI Tripod Projection Screen User Manual

User Guide

FAVI Tripod Projection Screen

1.) Screen components

2.) Screen features

o Washable ma tt e whi te s ur fac e
o Enhanced gain for brighter and more vivid colors
o Stylish metal screen casing
o User friendly
o Long lasting, fire-resistant screen case and fabric
o Advanced anti-static sc reen f abr ic resi stant to dust

3.) Operation instructions

Assembling the screen:

- Set the tripod up by extending its legs. To extend or retract the legs, g r as p the top piece
where the legs meet. Slide it down to extend the tripod’s legs, and up to retract them.

- Locate the small peg on the back of the screen’s casing.

- On the tripod near the bottom is a socket that this peg fits into. Press and hold open the
red latch around the so cket, a nd i nsert the peg into i t. (On Version B tripods that are used
for the larger screens, this latch is colored blue.)

- Release the latch. The bottom of the screen should now be secured to the tripod.

- Grasp the top of the screen and raise it. Place the supporting rod into the notch at the
top of the tripod as shown in the following diagram:

- To raise the top of the tripod, locate the lever at the upper end of the bottom section.
Open this lever, raise the top of the tripod until it reaches the desired height, then
close this lever to lock i t into pl ace.

(Version B tripods have a blue button on the upper end of the bottom section instead
of a lever. Press and hold this button in, then grasp the top of the tripod and raise or
lower it to the desired height. The top section will lock into place at one of several
height positions.)

- To extend the bottom of the screen, open the lever on the bottom piece that the
screen is connected to, and pull it down until the screen is fully extended. Then close
this lever to lock the bottom piece into place. (On Version B tripods, press and hold in
the blue button, then raise or lower the bottom piece until it locks into place.)

Disassembling the screen:

-Lower the upper section of the t r ipod.

- Remove the top supporting rod from the top of the tripod, and lower the screen until it’s

fully retracted.

-Hold down the latch and pull the screen out of the socket on the tripod.

-Raise the bottom piece, then retract the tripod legs .

4.) Safety and Maintenance Instructions

-Please handle this screen with care during transportation and installation.

-Please do not fold the screen fabric.

-Please keep any sharp objects away from the screen’s surface.

-Water and a soft cloth are recommended for cleaning the screen’s surface. Harsh
chemicals or excessive humidity could damage your screen.

-Please keep the screen away from high temperatures.

-Please store this screen in a dry environment.

-Please make sure the screen is clean prior to storing it in a safe place.