Fat Bagger CHIN SPOILER User Manual

FBI CHIN SPOILER INSTALLATION
WARRANTY
Fat Baggers, Inc.™ warrants to the original purchaser that the parts of this Chin Spoiler to be free of manufacturing in materials and workmanship for a period of 1 year from the date of purchase. In the event warranty service is required, you must call Fat Baggers, Inc.™ immediately with description of the problem. If it is deemed necessary for Fat Baggers, Inc.™ to make an evaluation to determine whether the part is defective, a return authorization number will be given by Fat Baggers, Inc.™ The parts must be packaged properly so as to not cause further damage and returned prepaid to Fat Baggers, Inc.™ with a copy of the original invoice of purchase and a detailed letter outlining the nature of the problem. If after the evaluation by Fat Baggers, Inc. the part was found to be defective it will be repaired of replaced at not cost to you. If we replace it, we may replace it, with a reconditioned one of the same design. Fat Baggers shall not be held liable for any consequential or incidental damages resulting from the failure of a Fat Bagger’s Inc. part. Fat Bagger’s shall have no obligation if a part be comes defective as a result of improper installation or abuse.
IMPORTANT NOTICE
Before installing this product, read through these instructions completely; this will familiarize you with the way in which parts fit together and the tools needed to complete the installa­tion. Fat Baggers, Inc.™ STRONGLY recommends this conversion be done by an experience motorcycle mechanic. Before performing any installation steps, disconnect the motorcycle’s battery to eliminate any possibility of damage to the electrical system or injury to yourself due to short circuit.
DISCLAIMER
These Fat Bagger parts are designed for high performance motorcycle applications and are intended for the very experienced rider only. The installation of these Fat Bagger, Inc.™ parts may adversely effect or void your factory warranty.
FAT BAGGERS, INC. 38 EAST LINCOLN CHARITON, IOWA 50049
Phone: (641)774-7499 Fax: (641)774-7505 www.fatbaggers.com
(641)774-7499
1. Begin your installation by removing the reectors on the down tubes, they are easily pulled off.
Then use some carburetor cleaner or other solvent or adhesive remover to remove the sticky resi-
2. Take off nuts and washers to remove rthe backing strap Then position the chin spoiler in place with voltage regulator protruding through the hole in its face. You’ll need to move some lines or cables around to get it to sit into place. Line up the steel backing strap and loosely put on washers and locking nuts.
www.fatbaggers.com
3. Now tighten the lock nuts into place. Be careful not to over-tighten so you don’t crack the berglass.
Loading...