Fast Precision Technologies TON9108 User Manual

TON9108-Datasheet
TON9108 – Low Power iBeacon
Charateristics
Contains ultra low power BLE4.0 IC Wide power supply range (2.35V ~ 3.3V) Ultra low iBeacon mode average power consumption (< 32uA @ 3 Broadcasts/Sec) Integrated 2Mbit flash for data and program storage Integrated real-time clock for time keeping Fully compatible with any BLE enabled smart phones (IOS, Android, WP) Companion iBeacon configuration smart phone application available for free Water resistant FCC, CE certified.
Applications
O2O E-commerce Indoor location service Advertising Context-aware computing
Rev. 1.02 - 1 - Fast Precision Technology Co. Ltd.
TON9108-Datasheet
Dimensions & Weight
Size: 50x50x10 mm Weight: 13.7 (g)
Rev. 1.02 - 2 - Fast Precision Technology Co. Ltd.
TON9108-Datasheet
Descriptions
TON9108 is a fully integrated, ready-to-assemble, iBeacon PCBA module for any Bluetooth low energy (BLE) technology based wireless beacon or iBeacon application. TON9108 features one of the world’s lowest powered BLE integrated circuit (DA14580), with 2Mbit of program and data flash memory. With the companion configuration applications software, a user can configure the iBeacon module remotely via any smart phone that is equipped with BLE technology. A user could easily set UUID, major and minor ID, broadcast interval, broadcast transmit power and other useful parameters etc. Once configured, the iBeacon hardware will broadcast its ID periodically according to the user configuration, this periodically emitted signal allow smart phone nearby to sense the iBeacon location and enable a rich interactive shopping experience for the consumers and businesses alike.
Case
Material: ABS
Power Supply
Battery powered: 220mA.Hr CR2032 coin cell battery
Internal Functional Diagram
TON9108 Circuit
DA14580(BLE)
MCU
~
2Mb
Flash
Rev. 1.02 - 3 - Fast Precision Technology Co. Ltd.
TON9108-Datasheet
Table of Contents
TON9108 – Low Power iBeacon .................................................................. 1
Charateristics ................................................................................................ 1
Applications .................................................................................................. 1
Dimensions & Weight ................................................................................... 2
Descriptions .................................................................................................. 3
Case ............................................................................................................... 3
Internal Functional Diagram ........................................................................ 3
1. Absolute Maximum Rating .................................................................. 5
2. Electrical Characteristics .................................................................... 5
3. Function Description ........................................................................... 6
3.1. Configuration ..................................................................................... 6
3.1.1. Initialization................................................................................... 6
3.2. Running .............................................................................................. 6
4. Package Descriptions .................................................................................. 7
Rev. 1.02 - 4 - Fast Precision Technology Co. Ltd.
TON9108-Datasheet
1. Absolute Maximum Rating
Absolute Maximum Rating(Ta = 27˚C)
Name Notation Value Unit
Supply Voltage
Voltage to any IC pin
Storage temperature
Note:
Module could be damaged if its use conditions exceed above listed conditions, when working under normal conditions,
the working conditions should be controlled below the maximum rating.
Normal working conditions
Vdd
Vin
T
STG
-0.5 to 3.6
-0.5 to Vdd + 0.5
-40 to125
V
V
˚C
Condition Min Typical
General
Supply Voltage
Working temperature
2.35
-40
3.0
25
Max Unit Note
3.3
85
V
˚C
2. Electrical Characteristics
Unless specially noted, the working conditions of the module shall be within the specified range as listed below. (VCC=3.0V)
Characteristics Min
Work Current
Rx Active
Tx Active
Deep Sleep
Power Management
Start-up Time
RTC crystal startup time
RF characteristics
RX sensitivity
Max Tx Power
Frequency Band
Broadcast characteristics
Broadcast frequency
Transmit duration
-20 0
Typ
6.1
5.8
1.5
1
0.4
-93
2400~2480
3
500
Max Unit Note
7.5 mA
7.2 mA
uA
mS
S
dBm
0 dBm
MHz
Times/Sec
uS
Rev. 1.02 - 5 - Fast Precision Technology Co. Ltd.
TON9108-Datasheet
Note
3. Function Description
3.1. Configuration
TON9108’s parameters such as UUID, major and minor number, transmit interval, etc. can be configured via our smart phone application software “BeaconFlyer”.
3.1.1. Initialization
TON9108’s is powered up as soon as the battery is attached to the internal PCB module and will continue to run until the battery is drained.
Pairing:
TON9108 is conformed to Bluetooth 4.0 standard, and can be detected and paired up with any Bluetooth 4.0 compliant host device.
3.2. Running
Once Powered, TON9108 will transmit beacon signal with specified transmit power level at the specified frequency.
Rev. 1.02 - 6 - Fast Precision Technology Co. Ltd.
4. Package Descriptions
TON9108-Datasheet
Rev. 1.02 - 7 - Fast Precision Technology Co. Ltd.
TON9108-Datasheet
Contact Information:
Fast Precision Technologies Co. Ltd.
Rm. 701 Zhengtailai Commercial Bldg.
Xixiang Road, Bao An District, Shenzhen
ZIP: 518102
Tel: (755) 8622-7153 Fax: (755) 8622-7139
© Fast Precision Technology Co. Ltd. 2015
All rights are reserved. Reproduction in a whole or in part is prohibited without the prior written consent of the
copyright owner.
The information presented in this document does not form part of any quotation or contract, is believed to be
accurate and reliable and may be changed without notice. No responsibility or liability will be accepted by the
publisher for any consequence of its use. Publication thereof does not convey nor imply any license under patent- or
other industrial or intellectual property rights
Printed in Shenzhen, China Date of release: 2015 October Document order number: 2015 0010 0001
Rev. 1.02 - 8 - Fast Precision Technology Co. Ltd.
Loading...